Replaces the worn out surge protection board in your 30 amp Active Controls ActiveStart plug-in soft start for RVs. Lets you continue to use your ActiveStart with surge protection once the old one absorbs damaging voltage surge.
If you keep tripping breakers while your AC runs, this soft start will keep your AC from drawing too much power at startup. It also protects your rig from surges, has a replaceable surge module, and supports remote firmware updates.
When you bleed pressure just to swap tools or close a line, you lose time waiting for your compressor to recover. This in-line valve lets you shut things off with a quarter turn and hold pressure in the system so you can keep working.
Control your vehicle's lights, air compressor, batteries, air lockers, and more, all from a single 8-switch panel. Control box mounts under the hood and powers switch panel via the included wiring harness.
Some valve stems are tucked behind a fender or sit at a weird angle. This short, flexible hose gives you a little slack at the valve so you can connect the chuck without bending the main line or working at an awkward angle.
Some air chucks leak or pop off unless you hold them in place. This one pushes on and locks down so you can let go while the tire inflates. The internal shut-off keeps air in the system when it's not connected to a valve.
Control your vehicle's lights, air compressor, batteries, air lockers, and more, all from your phone or the 8-switch panel. Bluetooth-enabled control box mounts under the hood and powers switch panel via the included wiring harness.
Some valve stems are buried deep or sit at the wrong angle for a standard chuck. This dual-head chuck with a flexible hose gives you the reach and angle you need to push the chuck onto the valve and fill the tire, even in tight spots.
Make it easier to reach your winch control plug with a 3' extension cord. Lets you plug in your wired controller even if your winch is mounted in a hard to reach location.
You've got a compressor mounted in your truck or set up in the shop, so you're not about to move it. This hose lets you air up tires or run pneumatic tools up to 30 feet away. Works with most compressors using 1/4" connections.
Repairs the latching mechanism in your BedSlide truck bed slide. Works with all BedSlides made between 2010 and 2013. Kit includes 2 lock pins, 2 springs, 2 hairpin clips, and instructions.
Equip your Adarac Aluminum Series ladder rack for your next overlanding adventure with these custom-fit side rails. T-slots on either side of the rails hold traction boards, Jerrycans, and other channel-mount accessories.
These custom-fit accessory bars let you carry more gear on your Adarac Aluminum or Pro Series ladder rack. Integrated channels in the top and bottom of the bars let you mount accessories that work with T-slots.
Equip your Adarac Aluminum Series ladder rack for your next overlanding adventure with these universal-fit side rails. T-slots on either side of the rails hold traction boards, Jerrycans, and other channel-mount accessories. Trim rails to fit.
These universal accessory bars let you carry more gear on your Adarac Aluminum or Pro Series ladder rack. Integrated channels in the top and bottom of the bars let you mount accessories that work with T-slots. Trim bars to fit as needed.
Equip your Adarac Aluminum Series ladder rack for your next overlanding adventure with these universal-fit side rails. T-slots on either side of the rails hold traction boards, Jerrycans, and other channel-mount accessories. Trim rails to fit.
These universal accessory bars let you carry more gear on your Adarac Aluminum or Pro Series ladder rack. Integrated channels in the top and bottom of the bars let you mount accessories that work with T-slots. Trim bars to fit as needed.
These universal accessory bars let you carry more gear on your Adarac Aluminum or Pro Series ladder rack. Integrated channels in the top and bottom of the bars let you mount accessories that work with T-slots. Trim bars to fit as needed.
Equip your Adarac Aluminum Series ladder rack for your next overlanding adventure with these universal-fit side rails. T-slots on either side of the rails hold traction boards, Jerrycans, and other channel-mount accessories. Trim rails to fit.
This 7-way to SAE cable connects your vehicle with a 7-way RV style connector to a SAE power cable. Works with any 12V accessory that has a SAE connector on its power cord.
Busted your running board? This replacement passenger's-side board fits your Aries ActionTrac kit (AA3025179), getting your step system working like new. Installs using your existing brackets and wiring - no need to start from scratch.