Got a mid-vehicle battery setup? A seamless installation means less time in the garage and more time on the trails. This kit has pre-crimped cables, fuses, and connectors for batteries up to 14'9" apart. Made for the Redarc BCDC Alpha 50A.
Multipurpose cable lets you wire a solar panel with Anderson connectors to a solar charge controller with hardwire inputs. Also can be used for adding extra cable length to solar panels, or connecting to chargers or battery management systems.
This custom battery tray mounts to the floor of your RV or camper to keep your Alpha150 battery securely locked in place during travel. Quick and simple installation with countersunk fasteners.
Got a mid-vehicle battery setup? A seamless installation means less time in the garage and more time on the trails. This kit has pre-crimped cables, fuses, and connectors for batteries up to 14'9" apart. Made for the Redarc BCDC Alpha 25A.
Need to get your PowerDock wired up for your next adventure? This kit makes it easy with color-coded cables, tough hardware, and room to customize. It's built for rough trails, so you can get set up and get going in no time!
Side mounts work with corner mounts (RED79VR - sold separately) to attach single or multiple Redarc solar panels to an RV or boat. Attach mount to surface using a silicon adhesive or common fasteners.
Got a rear-vehicle setup? A seamless installation means less time in the garage and more time on the trails. This kit has pre-crimped cables, fuses, and connectors for batteries up to 21"4" apart. Made for the Redarc BCDC Alpha 25A.
Beach, campsite, or worksite - take your adventures off-grid! This all-in-one kit makes connecting your PowerDock a cinch. Hook up solar panels, power up anywhere, and rely on rugged Aussie durability to tackle the wild.
Got batteries close together? This kit has pre-crimped cables, fuses, and connectors for batteries less than 5' apart. Made for the Redarc BCDC Alpha 50A.
Replace 2 worn or damaged backing plates on your single-axle trailer fender. Backing easily blocks water and road debris from hitting the side of your trailer.
Coupler repair kit contains all needed replacement parts for your CE Smith straight-tongue coupler with a 3,500-lb or 5,000-lb capacity, except for the coupler housing.
These brackets let you mount your single-axle fenders with side steps to your trailer. Includes 2 bolt-on, galvanized brackets to mount one fender. Works with CE19502, CE19503, CE19504 fenders (sold separately).
This towing safety flag is ideal for your kayak, SUP, or anything else you want to tow and draw attention to. Made of Oxford fabric and nylon webbing, so it holds up for the long haul.
This rust-resistant bracket lets you mount a bunk board vertically on your boat trailer. It's adjustable, so if you need to move your bunk up or down, just loosen the bolts a little and adjust as needed.
Replace 1 worn or damaged backing plate on your single-axle trailer fender. Backing easily blocks water and road debris from hitting the side of your trailer.
Install your Curt electric trailer brake controller quickly and easily with this custom wiring adapter. Simply plug one end of the adapter into your controller and then plug the other end into the built-in port beneath your vehicle's dash.