Replaces the rubber gaskets on your LaSalle Bristol black-water waste valve. Prevents sewer water from slowly leaking out of the valve. Includes two seals for both sides of the valve.
Pipe assembly connects both drains in your dual-basin sink to a single 1-1/2" pipe. Seals included. Made of ABS plastic. Measures 11" center to center.
This 1/2" cone washer creates a watertight seal in your RV's PEX plumbing system. Seats snugly in faucet or toilet fittings to stop leaks and keep your fresh water lines drip-free.
Replaces the stopper in a LaSalle Bristol drains for bathroom sinks. Includes ring seal so you can fill your sink with water without it slowly draining out.
Replace a cracked or faded switch bezel on your Power Gear leveling system with this black/silver trim piece. Snaps in easily for a quick cosmetic fix. Works on select Power Gear RV leveling system control panels.
Replace your RV's awning roller and fabric with a heavy-duty assembly. Fits Solera 20' power and hybrid awnings extending 8'. Includes LED strip sleeve. Easier than replacing fabric alone.
Replace your RV's old or damaged awning roller and fabric with this heavy-duty assembly. Fits Edge and 2000 series 8' power awnings with a built-in LED strip. Installs more easily than replacing just the fabric.
Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.
A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.
Wish you had a quick way to swap out your batteries? Well, you do now. Easily slide this tray out of your RV so you can monitor, replace, or disconnect your batteries without wasting time rooting around a cluttered or cramped cargo compartment.
Restore your Solera Edge slide-out awning with this full idler side replacement kit. Designed for all Solera Edge toppers, it includes black-finished hardware and wire support components for a secure, like-new installation.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.
Need an air distribution box for your ductless Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
Bring your guide-on back to life with this genuine replacement post for your 22" pontoon post guide-on setup. Made from durable, white PVC, it drops right onto your existing brackets to get you back on the water faster.
Replace 1 worn or damaged backing plate on your single-axle trailer fender. Backing easily blocks water and road debris from hitting the side of your trailer.
The breeze is perfect, but now a rip threatens your bug-free night. With these patches in your pack, you fix the hole in seconds and relax, knowing nothing will crawl in as you drift off to sleep.
Restore connectivity between your switch panel and RV generator with this 10-foot Cummins Onan adapter harness. Designed for use with remote start/stop control panels on HGJBB, KY, and HGJAx model generators.
You're swapping out your RV's AC and need a distribution box to match. Open the louvers for cool air directed straight into the cabin, or close them to push air through existing ducts. Includes a filter that pops out for a quick rinse.