Restore your Solera Edge slide-out awning with this full idler side replacement kit. Designed for all Solera Edge toppers, it includes black-finished hardware and wire support components for a secure, like-new installation.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
Passenger's-side electric trailer brake measures 10" x 2-1/4" and is made for Lippert ABS systems. Brake pads are made of friction material for improved braking and longevity. Fits 13" to 15" wheels.
Need an air distribution box for your ductless Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.
With this panel kit, you can turn your Kuat Ibex rack into a high-quality truck topper. This makes it easier to carry anything you don't want exposed to the weather.
Your Kuat Ibex truck bed rack is decked out with the panel kit, but now it's time to make room up top for your gear. These risers add 3" to 4" of lift to your crossbars.
You outfitted your Kuat Ibex truck bed rack with panels for a secure, enclosed topper, but organization is just as important. This MOLLE panel mounts inside the door panel so you can mount gear.
This recovery ring increases the pulling power of your winch in a double line pull or lets you change the direction of your single line pull. Works with Maxtrax synthetic winch rope and soft shackles. 55,114 lbs breaking strength.
We curated this compact winch recovery kit to replace your heavy, steel setup. The whole kit weighs a mere 22 lbs and includes a synthetic winch rope, shackles, and everything else you need to make safe, effective recoveries. Includes carry bag.
This rope dampener hangs over your recovery line to prevent snapback if there's a failure in your Maxtrax rigging setup. The dual sleeves let you add weights, like rocks or sand, so the dampener can absorb the force if the line breaks.
We curated this kit so you can recover a stuck vehicle from almost any distance. There is less risk of injury or gear damage since the ropes and shackles are made from a tough synthetic material that's stronger than steel and safer to use.
Replace a missing or damaged lift knob on your MaxxFan Plus roof vent so you can still open or close the dome when power is out. 3-wing design gives you a solid grip and installs in seconds to keep fresh air flowing.
Replaces the control keypad on your MAXXAIR MaxxFan Plus roof vent. Works with 4700CN, 4700G, 4900G, 4700D, 4900D, 4700N, 4900N, 4700CN, 4751KS, 4951KS, 4951KSC, 74951KS, and 74751KS model fans.
Replace your damaged MegaSport trailer fender with this direct-fit galvanized steel upgrade. Fits MPG535, MPG550 & MPG595. Rust-resistant, road-tough, and ready to protect your gear from grit, debris, and highway spray.
Mount this rugged rack on your Malone trailer to haul a heavy e-bike up to 200 lbs. Extra-long tray, built-in ramp, and padded locking arm make loading and transport easyeven with fat tires and wide axle spacing.
J-style racks can tap out with wide yaks. This kit adds full-length, padded support to your truck or trailer - no pressure points, no hull dents, no wobble. Perfect for fishing kayaks or any setup that needs more than a strap and a prayer.
Swap out bent or corroded fender brackets on your Malone MegaSport trailer with this factory-style replacement. Built tough to handle road abuse and keep your galvanized fender secure on MPG535, MPG550, and MPG595 models.
Don't let a flat tire delay your adventure. This full-size spare is made for Malone's off-road trailers and includes a lockable mount that secures directly to the frame, so it stays put when the road gets rough.
A 3-piece design makes this an all-around performer. The rubber top and base are grippy and stable, while the plastic core supports over 40,000 lbs. Supports trailer jacks and stabilizers or can be used as leveling blocks for even the largest RVs.