Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.
Replace or add a reverse lockout solenoid to your surge brake actuator from Dexter or Tie Down Engineering to keep the actuator from activating your trailer brakes when you shift into reverse.
Replace a worn or leaking copper washer on your Dexter disc brake caliper. This 7/16" crush washer provides a tight, reliable seal between the banjo fitting and caliper to help prevent brake fluid leaks in your hydraulic braking system.
This replacement inner member slide easily fits into the existing housing of your Dexter XR84 or Legacy UFP surge brake actuator. For use with triple-axle trailers with hydraulic disc brakes.
Replaces the protective top cap on Dexter 12,000-lb hydraulic jack add-on with selector valve; keeps internal components shielded from debris and moisture.
Need a tough, reliable connection from your actuator to the main brake lines? The non-stick polymer core locks in pressure, while braided stainless steel fends off road debris. No ballooning, no leaks, just reliable stopping power.
280" Line is most often used to connect your actuator to the rest of your hydraulic system. Brass fittings won't rust and are easier to work with than stainless steel.
This stainless steel acorn lug nut laughs in the face of rust. Perfect for saltwater use, it stays strong and rust-free. No chipping, no peeling, just a tough, reliable fit that shrugs off moisture, salt, and road grime for the long haul.
Keep your Dexter axle properly lubed with these press-in grease zerks. Designed for E-Z Lube and Nev-R-Lube axles, they let you easily attach a grease gun for routine maintenance. Measures 1/4" outer diameter x 5/16" length.
This replacement inner member slide easily fits into the existing housing of your Dexter XR84 or Legacy UFP surge brake actuator. For use with single or tandem-axle trailers with hydraulic disc brakes.
Replaces the "D" washers, retainer nuts, and hex nuts needed to secure the brake hubs on your Dexter trailer axle manufactered after June of 2002. Includes 2 "D" washers, 2 retainer nuts, and 2 hex nuts.
Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.
This replacement inner member slide easily fits into the existing housing of your Dexter A-84 Series or Legacy UFP surge brake actuator. For use with single or double-axle trailers with hydraulic disc brakes.
Upgrade your boat trailer's braking power with this rust-resistant GalvX disc brake. Kit includes 1 pre-greased hub, inner (L68149) and outer (L44649) bearings, rotor, caliper, mounting brackets, and lug nuts.
This stainless steel acorn lug nut laughs in the face of rust. Perfect for saltwater use, it stays strong and rust-free. No chipping, no peeling, just a tough, reliable fit that shrugs off moisture, salt, and road grime for the long haul.
Replace a worn or damaged clevis on your first-generation Demco Excali-Bar tow bar (9511006) with this exact-fit part. Built to keep your tow bar securely attached to your base plate, it restores the solid link your flat towing setup relies on.
Install this manual reverse lockout so that you can back up your vehicle without triggering your trailer's brakes. Lockout installs on any Demco Model DA75 hydraulic brake actuator and is easily activated by hand. No wiring required.
Need a tough, reliable connection from your actuator to the main brake lines? The non-stick polymer core locks in pressure, while braided stainless steel fends off road debris. No ballooning, no leaks, just reliable stopping power.