Replaces the prop rod assembly on your Leer tri-fold tonneau cover (631303, 631105, 631286, and 631335) or quad-fold tonneau cover (650400, 650149, and 650320).
You roll the carrier into place without strain, easing it out of the hitch and onto smooth ground so you can unload without lifting and get back to the rest of your day.
Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.
A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.
Restore your Solera Edge slide-out awning with this full idler side replacement kit. Designed for all Solera Edge toppers, it includes black-finished hardware and wire support components for a secure, like-new installation.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.
Need an air distribution box for your ductless Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
Replace a damaged or worn spring bar on your Curt TruTrack 2P system with this forged steel bar. Designed for 5,000-lb to 8,000-lb setups only (17599). Restores sway control and load leveling for safer, more stable towing.
Install your Curt electric trailer brake controller quickly and easily with this custom wiring adapter. Simply plug one end of the adapter into your controller and then plug the other end into the built-in port beneath your vehicle's dash.
Replace 2 worn or damaged backing plates on your single-axle trailer fender. Backing easily blocks water and road debris from hitting the side of your trailer.
Coupler repair kit contains all needed replacement parts for your CE Smith straight-tongue coupler with a 3,500-lb or 5,000-lb capacity, except for the coupler housing.
If you're tired of steel brackets rusting out on your boat trailer, try this aluminum bracket. It's lightweight, durable, and won't rust, so your tail lights stay mounted season after season no matter where you launch.