Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
Need an air distribution box for your ductless Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
Replace a missing side plug on your Lippert Power Tongue Jack V2. Push-in rubber cover (1-3/8" OD) seals the jack-head opening to keep out water, dirt, and road grimerestoring full protection in seconds, no tools required.
A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.
Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.
Use this Grade 5 flange nut with Grade 5 bolts (sold separately) to mount your Lippert components on your RV. Secures your steel or aluminum, manual pull-out Tread Lite steps or Ground Control 3.0 front jacks. Zinc plated to resist corrosion.
This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.
Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.
Replace the spacer on your Kodiak K71-2R-11-10D-DDDD disc brake kit. Designed for 11" rotors with an 8 on 6-1/2" bolt pattern and 5/8" studs, it restores fit and function for your 10,000-lb axle, keeping disc brakes working smoothly.
Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.
Caliper-mounting bracket is designed for use with 11.6" hub-and-rotor assemblies that have an 8 on 6-1/2 bolt pattern and 5/8" wheel bolts. Works with dually applications and mounts on 7-bolt, 10,000-lb Dexter brake flanges.
This custom floor for your Kelty Late Start 4-person tent is like a bodyguard for your tent floor, blocking moisture and protecting against sharp rocks. Because nothing ruins a campout faster than getting soaked because your tent bottom leaks.
Avoid slipping or falling while hiking with these rubber tips for your Kelty trekking poles. They slide over the tips to give your poles extra grip on rock or any other hard surface. They even reduce noise so you won't scare off wildlife.
This custom floor for your Kelty Late Start two-person tent is like a bodyguard for your tent floor, blocking moisture and protecting against sharp rocks. Because nothing ruins a campout faster than a soggy tent bottom with rips and tears.