Replaces the rubber gaskets on your LaSalle Bristol black-water waste valve. Prevents sewer water from slowly leaking out of the valve. Includes two seals for both sides of the valve.
Pipe assembly connects both drains in your dual-basin sink to a single 1-1/2" pipe. Seals included. Made of ABS plastic. Measures 11" center to center.
Replaces the stopper in a LaSalle Bristol drains for bathroom sinks. Includes ring seal so you can fill your sink with water without it slowly draining out.
Replaces the installation mounting hardware for your Longview original custom towing mirrors (LVT-3100B). Includes 2 clips, 2 knobs, and felt pads - enough for 1 pair of mirrors.
Replaces the OneControl Advantage controller with Bluetooth for your Lippert Level Up RV leveling system. Fits all Lippert Level Up leveling systems. Includes flat mounting brackets and hardware.
Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.
A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.
Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.
Avoid slipping or falling while hiking with these rubber tips for your Kelty trekking poles. They slide over the tips to give your poles extra grip on rock or any other hard surface. They even reduce noise so you won't scare off wildlife.
This custom floor for your Kelty Late Start two-person tent is like a bodyguard for your tent floor, blocking moisture and protecting against sharp rocks. Because nothing ruins a campout faster than a soggy tent bottom with rips and tears.
Use this Grade 5 flange nut with Grade 5 bolts (sold separately) to mount your Lippert components on your RV. Secures your steel or aluminum, manual pull-out Tread Lite steps or Ground Control 3.0 front jacks. Zinc plated to resist corrosion.
This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.
Replaces the outer CV boot for your GSP heavy duty axle assembly. Flexible TPEE rubber boot protects the CV joint from debris and helps keep it lubricated. Includes boot, moly grease, and all hardware to replace 1 outer boot.