New Arrivals

Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.

• Accessories and Parts
• RV Steps
• Motors
• Control Module
• Steps
• Lippert

This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.

• Accessories and Parts
• RV Awnings
• Arms
• Pitch Arms
• Lippert

Replaces the cartridge valve for your Lippert Flow Max kitchen or bathroom faucet.

• Accessories and Parts
• RV Faucets
• Cartridge
• Lippert

Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.

• Accessories and Parts
• RV Awnings
• Arms
• Drive Arms
• Lippert

Replaces the mount for your Solera 3000 Series RV awning.

• Accessories and Parts
• RV Awnings
• Mounting Hardware
• Lippert

Replaces 1 3/8" x 1-11/32" pin needed for your Solera RV awning. Dacromet finish resists corrosion.

• Accessories and Parts
• RV Awnings
• Hardware
• Arms
• Pins
• Lippert

Electric ground supply and wiring harness connects to the controller, breaker, and battery of your Hall Effect leveling system.

• Accessories and Parts
• Camper Jacks
• Wiring Harness
• Lippert

A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.

• Accessories and Parts
• RV Awnings
• Extension Rod
• White
• Lippert

Replaces the control board for your Lippert OneControl electric Travel Trailer RV leveling system (672136).

• Accessories and Parts
• Camper Jacks
• Controllers
• Control Panel
• Lippert

Use this Grade 5 flange nut with Grade 5 bolts (sold separately) to mount your Lippert components on your RV. Secures your steel or aluminum, manual pull-out Tread Lite steps or Ground Control 3.0 front jacks. Zinc plated to resist corrosion.

• Accessories and Parts
• Camper Jacks
• Hardware
• Nuts
• Lippert

This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.

• Accessories and Parts
• RV Awnings
• Lights
• 16 Feet Long
• Strip Light
• Black
• Lippert

Replaces the motor assembly on your Lippert Coach RV steps.

• Accessories and Parts
• RV Steps
• Motors
• Lippert

This screwdriver-like tool is required to disconnect hoses from your JR Products LP Gas Manifold.

• Accessories and Parts
• Propane Fittings
• Tools
• Manifold
• JR Products

Add extra sturdiness to a fold-out tray, slide-out camp kitchen, or portable table. Once installed, this table leg will fold flat against whatever you mount it to. Leg height adjusts in 1" increments from 22-1/2" up to 35-1/2"

• Accessories and Parts
• Camping Table
• Table Legs
• JR Products

Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.

• Accessories and Parts
• Brake Actuator
• Hydraulic Drum Brakes
• Disc Brakes
• 4 Feet Long
• Brake Lines
• Brake Line Components
• Kodiak

Replace the spacer on your Kodiak K71-2R-11-10D-DDDD disc brake kit. Designed for 11" rotors with an 8 on 6-1/2" bolt pattern and 5/8" studs, it restores fit and function for your 10,000-lb axle, keeping disc brakes working smoothly.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• 10000 lbs
• Rotors
• Rotor Spacers
• Kodiak

Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.

• Accessories and Parts
• Brake Actuator
• Hydraulic Drum Brakes
• Disc Brakes
• 26 Feet Long
• Brake Lines
• Brake Line Components
• Kodiak

Caliper-mounting bracket is designed for use with 11.6" hub-and-rotor assemblies that have an 8 on 6-1/2 bolt pattern and 5/8" wheel bolts. Works with dually applications and mounts on 7-bolt, 10,000-lb Dexter brake flanges.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• 10000 lbs
• Hardware
• Caliper Parts
• Mounting Brackets
• Kodiak

Replaces 2 caliper retaining clips and 2 retaining clip bolts on your Kodiak DBC-338-HD calipers.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• Caliper Parts
• Bolts
• Kodiak

Replace the leveling sensor wiring harness in your Lippert Hall Effect RV levelling system with this replacement right rear sensor harness.

• Accessories and Parts
• Camper Jacks
• Remote Receiver
• Lippert

Replaces the 3/8" x 2-1/8" pin for your Lippert Solera RV awning. Dacromet finish provides corrosion resistance.

• Accessories and Parts
• RV Awnings
• Hardware
• Pins
• Lippert

Mounts the front jacks of the Lippert Ground Control 3.0 to your motor home.

• Accessories and Parts
• Camper Jacks
• Hardware
• Bolts
• Lippert

Replaces the left or right support arm for your 10' wide Thule Omnistor 5200 motorized awning.

• Accessories and Parts
• RV Awnings
• Arms
• Support Arms
• Lippert