New Arrivals

A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.

• Accessories and Parts
• RV Awnings
• Extension Rod
• White
• Lippert

Replaces the control board for your Lippert OneControl electric Travel Trailer RV leveling system (672136).

• Accessories and Parts
• Camper Jacks
• Controllers
• Control Panel
• Lippert

Use this Grade 5 flange nut with Grade 5 bolts (sold separately) to mount your Lippert components on your RV. Secures your steel or aluminum, manual pull-out Tread Lite steps or Ground Control 3.0 front jacks. Zinc plated to resist corrosion.

• Accessories and Parts
• Camper Jacks
• Hardware
• Nuts
• Lippert

This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.

• Accessories and Parts
• RV Awnings
• Lights
• 16 Feet Long
• Strip Light
• Black
• Lippert

Replaces the motor assembly on your Lippert Coach RV steps.

• Accessories and Parts
• RV Steps
• Motors
• Lippert

This screwdriver-like tool is required to disconnect hoses from your JR Products LP Gas Manifold.

• Accessories and Parts
• Propane Fittings
• Tools
• Manifold
• JR Products

Add extra sturdiness to a fold-out tray, slide-out camp kitchen, or portable table. Once installed, this table leg will fold flat against whatever you mount it to. Leg height adjusts in 1" increments from 22-1/2" up to 35-1/2"

• Accessories and Parts
• Camping Table
• Table Legs
• JR Products

Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.

• Accessories and Parts
• Brake Actuator
• Hydraulic Drum Brakes
• Disc Brakes
• 4 Feet Long
• Brake Lines
• Brake Line Components
• Kodiak

Replace the spacer on your Kodiak K71-2R-11-10D-DDDD disc brake kit. Designed for 11" rotors with an 8 on 6-1/2" bolt pattern and 5/8" studs, it restores fit and function for your 10,000-lb axle, keeping disc brakes working smoothly.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• 10000 lbs
• Rotors
• Rotor Spacers
• Kodiak

Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.

• Accessories and Parts
• Brake Actuator
• Hydraulic Drum Brakes
• Disc Brakes
• 26 Feet Long
• Brake Lines
• Brake Line Components
• Kodiak

Caliper-mounting bracket is designed for use with 11.6" hub-and-rotor assemblies that have an 8 on 6-1/2 bolt pattern and 5/8" wheel bolts. Works with dually applications and mounts on 7-bolt, 10,000-lb Dexter brake flanges.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• 10000 lbs
• Hardware
• Caliper Parts
• Mounting Brackets
• Kodiak

Replaces 2 caliper retaining clips and 2 retaining clip bolts on your Kodiak DBC-338-HD calipers.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• Caliper Parts
• Bolts
• Kodiak

Replace the leveling sensor wiring harness in your Lippert Hall Effect RV levelling system with this replacement right rear sensor harness.

• Accessories and Parts
• Camper Jacks
• Remote Receiver
• Lippert

Replaces the 3/8" x 2-1/8" pin for your Lippert Solera RV awning. Dacromet finish provides corrosion resistance.

• Accessories and Parts
• RV Awnings
• Hardware
• Pins
• Lippert

Mounts the front jacks of the Lippert Ground Control 3.0 to your motor home.

• Accessories and Parts
• Camper Jacks
• Hardware
• Bolts
• Lippert

Replaces the left or right support arm for your 10' wide Thule Omnistor 5200 motorized awning.

• Accessories and Parts
• RV Awnings
• Arms
• Support Arms
• Lippert

Need a thermostat for your ducted Furrion Chill Cube RV AC setup? This single-zone, wall-mounted unit lets you view and adjust the fan speed, mode, and more.

• Accessories and Parts
• RV Air Conditioners
• Thermostat
• Furrion

This kit replaces the roller assembly for your pop up camper.

• Accessories and Parts
• Camper Jacks
• Roller Assembly
• Lippert

A faulty harness can leave your leveling system unresponsive. Restore power and precision with this Deutsch 2-wire pigtail replacement. Designed for a secure fit, it ensures reliable connectivity so you can get back to smooth, worry-free operation.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Lippert wiring harness connects your current Hall Effect to your 4-point or 6-point control board. Includes wiring harness only.

• Accessories and Parts
• Camper Jacks
• Wiring Harness
• Lippert

Cozy cover zips on and off your child's RV mattress to protect it from dirt and grimy food. Teddy-bear-like material is comfy enough for your child to sleep soundly during your trip. Fits mattresses 68" long x 30" wide x 3" tall.

• Accessories and Parts
• RV Mattress
• Mattress Covers
• Bunk
• Gray
• Lippert

Replaces (1) wear collar for your Lippert Solera RV awning. 3/8" Inner diameter, 1/2" outer diameter x 1/2" long.

• Accessories and Parts
• RV Awnings
• Hardware
• Wear Collar
• Lippert

A faulty harness can make your RV's leveling system unreliable. This replacement restores secure connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's an easy fix to get you back on the road with confidence.

• Accessories and Parts
• Trailer Jack
• Camper Jacks
• Wiring Harness
• Lippert