Replace the spacer on your Kodiak K71-2R-11-10D-DDDD disc brake kit. Designed for 11" rotors with an 8 on 6-1/2" bolt pattern and 5/8" studs, it restores fit and function for your 10,000-lb axle, keeping disc brakes working smoothly.
Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.
Caliper-mounting bracket is designed for use with 11.6" hub-and-rotor assemblies that have an 8 on 6-1/2 bolt pattern and 5/8" wheel bolts. Works with dually applications and mounts on 7-bolt, 10,000-lb Dexter brake flanges.
This custom floor for your Kelty Late Start 4-person tent is like a bodyguard for your tent floor, blocking moisture and protecting against sharp rocks. Because nothing ruins a campout faster than getting soaked because your tent bottom leaks.
Avoid slipping or falling while hiking with these rubber tips for your Kelty trekking poles. They slide over the tips to give your poles extra grip on rock or any other hard surface. They even reduce noise so you won't scare off wildlife.
This custom floor for your Kelty Late Start two-person tent is like a bodyguard for your tent floor, blocking moisture and protecting against sharp rocks. Because nothing ruins a campout faster than a soggy tent bottom with rips and tears.
Perfect for winter hikes, these snow baskets keep your Kelty trekking poles on top of the snow where they belong. No more digging them out like you're searching for ancient artifacts in the Arctic - your poles deserve better!
This custom floor for your Kelty Late Start one-person tent is like a bodyguard for your tent floor, blocking moisture and protecting against sharp rocks. Because nothing ruins a campout faster than a soggy tent bottom with rips and tears.
You outfitted your Kuat Ibex truck bed rack with panels for a secure, enclosed topper, but organization is just as important. This MOLLE panel mounts inside the door panel so you can mount gear.
Replaces the prop rod assembly on your Leer tri-fold tonneau cover (631303, 631105, 631286, and 631335) or quad-fold tonneau cover (650400, 650149, and 650320).
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
Need an air distribution box for your ductless Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
Replace a missing side plug on your Lippert Power Tongue Jack V2. Push-in rubber cover (1-3/8" OD) seals the jack-head opening to keep out water, dirt, and road grimerestoring full protection in seconds, no tools required.