2022 Fender Flares

The Rackem Fitz-All Enclosed Trailer Ladder Rack #RA-28 does adjust horizontally to allow it to fit trailer roofs from 4-feet to 8-1/2-feet wide but its height is fixed based on the position of the roof rain gutters, which are required in order to…

The Rack' Em Ladder Rack part #RA-28 that you referenced is rated for 400 lbs when used within it's length range of 4 foot to 8-1/2 foot. You'd be totally fine at 8-1/2 feet to use it's full 400 lb capacity as it was rated and tested…

We have found that the Replacement Motor #LG-142178 that you referenced is indeed compatible as a replacement for your existing Atwood 75722 motor.The only thing I recommend doing is verifying that the legs on your motor aren't flush with the…

Yes, the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10140 referenced in your question will fit the same 12 inch wheel with a 4 inch width that your existing 4.80-12 size tires are mounted to. Just note that the ST145/R12 tire will be…

We do carry a variety of different trim and edging. Unfortunately we do not have a way to look up a model of trailer to know exactly what kind of trim you will need. We would want to try to match the current trim as best we can. A very common roof…

The lights you referenced in the photo for the Aries Front Fender Flares #AA1500201 wouldn't be factory lights. There is a similar product available for your 2012 Jeep Wrangler Unlimited that work with the aforementioned Fender Flares. The Aries…

We have what you need. I will list them below for you. The Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin #BX88357 for your 1 inch D-rings. The etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates - RV Mount - 2" Hitch - 6,000…

For a bumper mounted spare carrier that has capacity for an 80 lb setup we have the part #BR56VR from Brophy that fits a 4 inch bumper like you have and would work well.

Demco has a base plate kit that fits your 2016 Jeep Rubicon Hard Rock with the part #DM56GV which is correct fit with the Demco Commander II part #DM9511012 you have as well.

For your 2022 Jeep Wrangler, the twist locks (the base plate tabs) will indeed connect to the end of the arms on the etrailer SD Non-Binding Tow Bar #e34ZR. You'll connect that directly to the Invisible Base Plate Kit #e98948. It's somewhat…

Based on the measurements you have provided it sounds like you have pretty standard wheel studs. Kodiak stud #K12WB2 is nearly spot-on as far as the measurements. I have included a picture showing its measurements for you.

Whether or not you can flat tow with a Jeep bumper is really up to the manufacturers testing; some of the big names like MetalCloak or Poison Spyder have bumpers with D-ring attachments that can be used for flat towing connections. This is great…