Features to know about

Secure Cargo in Any Weather: Fiberglass Reinforced Plastic Panels

Rain, dust, and road grime can ruin tools and gear left in the bed. This cover uses fiberglass reinforced plastic panels that are lightweight yet tough enough to keep out the elements. Rubber seals and reinforced, vinyl-coated panel hinges close up tight, keeping water and dust from getting in. The panels also have a slight arc that helps water roll off instead of pooling, so you don’t need drain tubes.

Full Bed Access When You Need It: Tri-Fold Design

When you need more space for a big load, you can fold up two-thirds of the cover in seconds. The integrated storage clips with retractable straps hold the panels in place while you drive. If you need the entire bed, the folded panels come off quickly without tools. It’s a solid setup for anyone who hauls gear that changes from day to day.

Streamlined Look Without Losing Function: Low-Profile Fit

The cover sits only about ½ inch above the bed rails, keeping a clean, flush look instead of sticking out. The black finish has a deep color that’s scratch resistant and impact absorbing, so it stays looking good even after years of use. The low profile also keeps stake pockets clear, leaving room for racks or other gear.

Simple Operation and Secure Closure: Tailgate-Latch System

It latches right at the tailgate, so you can open and close the cover easily without extra steps. When the tailgate is locked, the cover locks too, keeping your cargo secure. The side rails support the panels with a high strength-to-weight ratio, giving you a rigid structure rated to hold up to 400 lbs.

Quick Setup: No-Drill Installation

Getting it on the truck is straightforward. The cover clamps to the bed rails with no drilling required, and everything lines up cleanly. You end up with a tight fit that seals well and looks like it belongs there.