Replacement 4" Fixed Caster for Snap-Loc Dollies and Pushcarts - 375 lbs

Video Transcript for The Low-Down on the Replacement 4" Fixed Caster for Snap-Loc Dollies and Pushcarts

Today, we're taking a look at the replacement four inch fixed caster for Snap-Loc dollies and pushcarts. Now this fixed caster replaces a lost or broken caster on any standard wood dolly or your Snap-Loc moving dolly, push cart, or panel cart. We're looking at a heavy duty steel construction. It features the non-marking airless four inch polyurethane wheel with a ground contact width of about one and one eighth inches.The top plate here is a standard size top plate. So if we take measurements of that edge to edge going this direction, we're looking at three and three quarter inches. Side to side this direction, we're looking at two and a half inches.

Now these outer holes are separated on center by one and three quarter inches going that direction. Going this direction, they're separated on center by about two and seven eighths inches. The overall caster height measured from the bottom of the wheel to the top of the plate, got a measurement of about five to five and one eighth inches. The wheel diameter outside edge to outside edge measured four inches, and this unit has a weight capacity of 375 pounds. That's going to do it for today's look at the replacement four inch fixed caster for Snap-Loc dollies and push carts..