Troubleshooting 2017 Ford F-250 Error Message for Trailer Lighting Module
Updated 07/11/2018 | Published 07/09/2018
Question:
I have a Cedar Creek 38FLX fifth wheel with LED tail lights. When trailer is hooked up to 7 way on my 2017 F 250 7 way plug and turn left blinker on I get a Left turn fault showing. Should I install resistors to turn signal and brake light wiring to resolve?
asked by: Michael B
Expert Reply:
In order to help you troubleshoot this issue I need to ask you a few questions.
On the trailer, do the turn signals operate properly, meaning do they flash at the expected rate?
Were the LEDs installed recently as replacements or are they the original OEM lights?
Has the trailer operated correctly until now or has it always had this issue?
I ask these questions because the newer Fords have a fairly complicated trailer wiring setup and I have heard of this issue before. Sometimes the cause can be as simple as some trapped water or dirt in the vehicle 7-way socket, or in the connector that plugs into the rear of that socket. A bent electrical contact within the vehicle socket or trailer plug could also lead the truck's trailer wiring system to think there is a problem when there isn't. If that one trailer light has a bad ground that too could cause the error message.
That's why I ask if the trailer's exterior lights work. If the trailer turn lights operate as they should then the error message could just be an annoying quirk related to the truck's electronics.
Load resistors are sometimes needed to correct for hyper-flashing of LED lights when they are used in a turn signal application but this is usually the case only when LEDs are installed in place of standard incandescent bulbs. The low power draw from LEDs can "fool" wiring systems into thinking a bulb has blown out and this can trigger error messages.
If the trailer turn lights are working correctly I would not be concerned.
Product Page this Question was Asked From
7-Way to 4-Way/5-Way Trailer Adapter for Vehicles with Lamp-Out Sensors Towing Trailers with LEDs
- Custom Fit Vehicle Wiring
- Wiring Adapters
- Universal Fit
- 7 Blade to 4 Flat
- 7 Blade to 5 Flat
- Plug Only
- CURT
more information >
Continue Researching
- Shop: Hopkins Tow Doctor Trailer End Test Unit
- Shop: Hopkins Tow Doctor Vehicle End Test Unit
- Search Results: tester
- Q&A: Troubleshooting Hopkins 7-way Connector # HM48503 Having All Test Lights On But No Trailer Lights
- Q&A: Troubleshooting Trailer Running Lights that Turn Off after 3-5 Seconds
- Q&A: Trailer Tail Lights Come On for a Few Seconds then Shut Off with a 1996 Jeep Grand Cherokee
- Q&A: Three Flashing Lights on Hopkins 7-Way RV Style Trailer Connector HM48503
- Shop: Pack'Em Rack for Open Utility Trailers - Holds 3 Trimmers, 1 Blower, 1 Line Spool, 1 Cooler
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Shop: Trailer Wiring
- Q&A: Recommended Adapter to Prevent Bulb Out Error
- Shop: TecNiq LED Trailer Tail Light - Stop, Tail, Turn, Backup - Submersible - Oval - Red/Clear Lens
- Article: Trailer Wiring Diagrams
- Shop: Hopkins Adapter 7-Pole to 6-Pole Universal with LED Tester - Electric Brake Center Pin
- Shop: Trailer Connector Adapter w/ Lamp-Out Sensor Bypass - 7-Way RV to 7-Way RV - Vehicle End
- Search Results: 7 pin led adapter
- Search Results: c57003
- Shop: Roof Rack
- Search Results: tn33xr
- Q&A: Troubleshooting Intermittent Trailer Disconnected Message with Factory Brake Controller on Ford
- Search Results: ir59fr
- Shop: InfiniteRule Locking Pins for Lock N Roll Articulating Hitch for 2" Hitches - Qty 2
- Search Results: ts20048b
- Search Results: tecniq
- Video: Trailer Connector Adapter: The Breakdown
- Video: A Closer Look at the Torflex Lift Kit
- Video: Complete Breakdown of the Dexter Trailer Springs Over-Under Conversion Kit
- Video: A Closer Look at the Hook Probe Circuit Tester
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Hitch
on Custom Fit Vehicle Wiring
