Custom Fit 2002 Jeep Wrangler Accessories

As with most situations where products are updated, the differences between the Brake Buddy 2 and the Brake Buddy 3 #HM39524 may not be so obvious, or seem minute-but they do offer improvements in the functioning of the system. The Brake Buddy 3 now…

Yes, you will want to remove any rubber floor mat when you're installing the Brake Buddy Select 3 #HM39524. It doesn't say this in the instructions but it's still recommended. I confirmed this with my contact at Hopkins/Brake Buddy.

Towing your Jeep Wrangler TJ behind your motorhome requires a tow bar, a kit to connect the tow bar to the Jeep, a lighting solution, and a braking system. You also may need a way to maintain the Jeep's battery while towing and a high-low adapter…

The Operating temperature of the Blue Ox Patriot #BLU37TR is between -20ºF and 120ºF. As long as your temperatures will not drop below -20ºF you are safe to keep it stored all winter in the camper. Otherwise I recommend storing it a…

Since there isn't a 6-way to 4-way coiled adapter like you are looking for you'd have to piece together the kit you are in need of with the part #PK11604 for the 6-way, the part #RM-1064-B for the coiled wire section, and then for the 4-way…

The easiest system to set up and use is the Blue Ox Patriot #BLU37TR, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. You can adjust this to be as sensitive as you need for the braking of your towed vehicle.…

The Blue Ox Patriot Portable Braking System part #BLU37TR has an improved RF range for the remote over the previous model so there will be no issues with reception on even the longest of motorhomes. I spoke to Blue Ox and they said that they…

If you don't have power to your Blue Ox Patriot Portable Braking System then the first thing to do would be to plug another accessory into the outlet so you can ensure the outlet has power and is not the issue. If it outlet is good then the issue…

You are correct. If the Blue Ox Patriot part #BLU37TR is not moving the accelerometer would not sense braking and start applying the brakes.

It sounds like you are asking about connecting the breakaway switch of the Brake Buddy Classic 3 Portable Supplemental Braking System #HM39494. I cut out some pages from the instruction manual for you to check out, but what you'll do is actually…

Yes, the Roadmaster Diode part #RM-790 will prevent the trailer from backfeeding to the battery of your Jeep. You would just need to install it inline with the 12 volt accessory circuit and you would be set.

Yes the Roadmaster base plate kit part #RM-521424-5 that you referenced does fit the 2005 Jeep Wrangler you sent in a picture of as I can see that it has coil front suspension and not leaf spring front suspension.