CIPA Custom Towing Mirrors - Slide-On Mirror - CM10200 Review Video

For a trailer that has an angle iron frame like what you have what I would recommend is a system like the Reese Steadi-Flex part #RP66558 you referenced and have the outer brackets welded to the frame of the trailer since there isn't a clamp…

I would be happy to help you find a brake controller for your 1989 C/K Series Pickup. I recommend the Curt TriFlex Trailer Brake Controller item #C24VV. This is a proportional brake controller that works with trailers having up to four axles. It…

This is a fairly straightforward install. GM has already run some of the necessary wiring from the rear frame rail area to the engine compartment, so you will see a blue wire for the electric brake function, and an orange wire which provides 12 volt…

Yes, the Curt Trailer Hitch Receiver part #C15312 is a confirmed fit for your 2007 Chevrolet Silverado 3500 Dually 4x4. The Curt Trailer Hitch Receiver is a direct bolt-on fit which means no drilling or cutting is required. If you need a trailer…

The bolt holes on the Curt Trailer Hitch Receiver #C15302 sit across from each other 39" on center and are separated front to back by 7-1/2" on center. This is a custom fit for the following vehicles: 2008 - 2010 GMC Sierra 2500 - 6-1/2…

I have attached for you below a drawing of the Curt Trailer Hitch Receiver part #C15325 which shows both the distance between the frame brackets left to right and the distance between the mounting holes front to back. If you need anything else just…

I spoke with my contact at Curt and he put together a chart that has all of the dimensions of the hitches you referenced.

I reached out to my contact at Draw-Tite who was able to give me the dimensions for the Trailer Hitch #41945. He said that the #41946 is for GM frames so it won't fit your Ford E-450 Chassis. From the rearmost hole to the end of the receiver…

I'm not exactly sure between which points you want the measurement taken of the Curt hitch, part #C15324, so I took a few. On the mounting plates, outside to outside is 41 inches, inside to inside is 36-1/2 inches, and the bolt holes are 39-11/16…

The Curt hitch part #C13900 that you referenced is designed to fit frame widths that range from 31 to 41 inches in width based on the holes you use. Check out the picture I attached to see how the holes match up with frame widths as well.

I called our representative at Draw-Tite, and he informed me that Full-Size is used to differentiate from the smaller or mid-size Blazer model. If you have the bigger model Tahoe, or the full-size Tahoe, then yes, the Draw-Tite Class III Max-E-Loader…

According to my technical contact at Curt Manufacturing their Class V Hitch #C15302 will fit your truck, if it were equipped with a standard 265mm wide spare, with about an inch of extra space. The hitch was engineering with this tire size in mind.…