Rampage Euro Style Front Light Guards for Jeep - Black Powder Coated Steel

Video Transcript for Rampage Vehicle Trim - Front of Vehicle Trim - RA85660 Review

Today we're going to be taking a look at the Rampage, Euro style front light guards for Jeep's. They're going to be made from a black powder coated steel. These are going to fit certain years and models of the Jeep Wrangler and Wrangler Unlimited's. The light guards are going to protect your Jeep's headlights and front turn signals as well as reflectors from flying debris. It's going to make sure that it hits the guard instead of your actual lens on your headlights, turn signals and reflectors. Again, these are going to be made from a steel construction, nice, strong, durable finish to it. They're going to have a powder coat finish as well, so they're not going to rust or corrode, they're going to last a long time.

They're going to stand up well against the elements. The black finish is going to add a nice rugged look for your vehicle. These are going to be a custom fit for your vehicle, so custom fit design, easy do it yourself installation. It's going to come with your installation instructions, those are going to walk you through the installation process step by step. When it comes to the headlights, when placing these on, they've got these spring bars. These tabs are made to spring load against the sides of the headlights and if you need a tighter fit you can carefully bend them for a tighter fit.

You can adjust that a little bit but you want to be careful and when you do bend that or if you need too, you want to carefully do so, so you don't break that tab. It's also going to come with the included hardware. The screws are only going to be used for the reflector guards. These two pieces right here, they have two holes each and that's the only place where the screws are going to be used. It's going to come with some 3M double sided adhesive tape. That's going to get applied here on the back of each headlight guard, anywhere around the perimeter except where the three mounting tabs are located and simply the guard's going to snap into place around the perimeter of the headlight bezels.

You're going to notice a nice indention there to get these to snap on. When it comes to the turn signal guards, all you have to do is remove the bolt in harness in the turn signal assembly, place the guard on the front of the lens and then the guard will clip around the edge for a nice tight fit so it's got the built in clips on there as well. For the reflector guards, simply just place the guard over the fender reflector and install the included mounting hardware to get that secured. That's going to do it for our review of the Rampage Euro style front light guards for Jeep's.