Custom Fit 2000 Ford F-150 Accessories

The mounting bolt pattern of the brake assembly part #AKEBRK-35 that you referenced is 2-7/8 inch by 2-7/8 inch like what you see in the picture I attached.

In order to install a Hayes brake controller like the Hayes Engage Trailer Brake Controller part #HA81760 on your 2000 Ford F-250 you will want to use the Custom Wiring Adapter part #HA81783-HBC which is a direct plug and play fit. I have attached a…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Yes, the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire #AM10140 referenced in your question will fit the same 12 inch wheel with a 4 inch width that your existing 4.80-12 size tires are mounted to. Just note that the ST145/R12 tire will be…

What you found is a DOT number and not a speed rating. I was able to figure out which tire you have and it's a Loadstar 4.80-12 that has a 65 mph speed rating. In this size we have a tire that can go 81 mph as part #TT48012C.

There is a very easy plug and play solution for you to install the Prodigy P2 Trailer Brake Controller part #90885 in to your 2000 Ford F-150. You will use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers part #3035-P. This will…

You are using the factory pigtail provided when you purchased the vehicle, not the #C51322, is that correct? If this is the case, the factory pigtail uses a different wire color code than the aftermarket ones, which match up color for color. Before…

Your 2000 Ford F-150 XLT Super Cab with manual transmission and 4.6L engine is capable of towing between 1,900 and 3,200lbs depending on your rear end gear ratio. These weight ratings are for conventional trailer towing. Ford does not provide any…

The factory brake controller plug should be located under the dash to the right of the steering column. It should be located towards the center of the dash and may be tucked up and out of the way behind some wiring. I have linked an FAQ Article that…

The only pin that should be continuously showing 12V power on the 7-Way connector on your vehicle is the 12V power circuit which is normally the black wire but not always. In 7-way wiring the 12V auxiliary power feed is carried on the contact at the…

Thank you for the photo of the TruXedo tonneau cover on your 1998 Ford F-150 Light Duty 6-1/2 Foot Bed Stepside. For this truck we offer two TruXedo soft roll-up covers, their TruXport #TX248601 for which the correct replacement tarp is part…

I do have a way you can upgrade your factory 4-Flat connector, but the needed plug to install the Curt #C55774 isn't there on your 2020 Ford F-150. This will only work for vehicle's that were originally equipped with the 7-Way from the…