Customers compare RVSTLB61 to these similar products
Products Featured in this Video
Hi there, trailer owners. Today, we're going to be taking a look at Optronics LED Surface Mount taillights. These are available in either the license plate bracket form here or in just the standard light configuration. Both of them are going to wire up exactly the same way and they're both going to have almost all the same features. The only difference between the two is you have the bracket for… see more >
Info for these parts were:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The anti-rattle adapter I recommend is the No-Rattle Trailer Hitch Wedge, part #MPG908. This will work for 1-1/4 inch and 2 inch receivers and is designed to insert into the small gap that may exist on your receiver. You then tighten it up after it…
view full answer...For an exact LED replacement from Command Electronics you need the following: - Driver Side #328-003-81LBM1 - Passenger Side #328-003-81BM1 These measure 8-11/16" long x 3-7/8" tall x 2" deep and have mounting holes measuring…
view full answer...The diameter for the valve stem hole on the Aluminum Jaguar Trailer Wheel #274-000011 is 0.625".
view full answer...Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…
view full answer...The only way will be to replace the entire assembly as the rear back plate is not available by itself. For that you'd need the part #RVSTLB61. The great news is that the price for this is very reasonable and you get an all new assembly.
view full answer...Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
view full answer...Most trailer wiring that runs to trailer lights is 16 gauge. I would rather people use 14 or 12 unless the lights are LED which draw considerably less. But for most people 16 gauge works just fine for basic trailer lighting. If you are planning on…
view full answer...I went out to the warehouse and pulled an Ultra-Fab Skid Wheels, #UF48-979011, to measure that plate for you. The length is just under 7 inches and the height or width is 4 inches. The plate is approximately 3/16 of an inch thick.
view full answer...The Low Profile LED RV Tail Light is available for the driver side as part #RVSTLB61 and the passenger side as part #RVSTLB60.
view full answer...While we do not carry a specific V-drag weld-on bar that protects your trailer from bottoming out, we do have an option that serves the same purpose. From the specs I have on your 2010 Forest River Cherokee Grey Wolf travel trailer, it measures 29.25…
view full answer...I can help you out here as we do have both the driver side and passenger Low Profile LED RV Tail Light. The matching passenger side has 9 diodes though because it does not have bulbs to light up the license plate. The two matching lights are the…
view full answer...For your 2008 GMC Sierra 3500 dually, there are differences on many parts depending on if you have the cab and chassis frame or the Heavy Duty truck. There are also sometimes differences based on the SRW versus DRW on certain brackets for correct…
view full answer...