Easy Grease Trailer Hub and Drum Assembly Feature Review Video

If you want to convert to a 5 on 5 bolt pattern the only option is for 3,500 lb axles. Assuming you have #L68149 inner and #L44649 outer bearings you could use #AKIHUB-550-35-EZ-K for an idler hub or #AKHD-550-35-EZ-K for a hub and drum assembly. If…

There is an easier solution that a different jack. You can use a longer ball mount so that the trailer, and the jack, will be further away allowing you to lower the tail gate without hitting the jack. Then you could use any jack you wanted. If that…

I am unaware of any specific place that has a spacer/extender which will work for your application in regards to the Loadstar ST175/80D13 Bias Trailer Tire with 13" Galvanized Wheel #AM3S130 rubbing your trailer frame. We do not recommend the…

The backspacing of Taskmaster 15 x 5-Inch Steel Modular Trailer Wheel #560550SM1 is 3-1/2-inches. I went to our warehouse and took this measurement for you. Do note that the 3-1/2-inches is the wheel's backspacing. Once you mount a tire on the…

The brake mounting flanges, whether they be 4 or 5 bolt, have a standard hole spacing to fit their appropriate brake assembly. No worries about the brake assembly matching with the existing one on your axle. A 3500 lb axle like what you have will use…

Self-adjusting brakes #AKEBRK-7-SA do not require that you travel in reverse for them to adjust. They can adjust themselves going forward or backward. Keep in mind that even self-adjusting brakes require 1 initial adjustment. You could just install…

It does take a few good and hard stops at full power (12 volts) in order to set the braking adjustment on a set of self-adjusting braking assemblies. That said, I would first make sure you are getting a full 12 volts out of your brake controller…

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

The Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 5-1/2 #AKHD-555-35-K will fit the spindle on your trailer to replace your AL-KO 8700 hub, but this does have a 5 on 5-1/2" bolt pattern. My information is the AL-KO…

Your single- or tandem-axle Carson Rebel travel trailer uses electric drum brakes. Brakes comes in different sizes for different axle weight ratings. For instance, a 3500-lb-rated axle will typically use brakes that measure 10 x 2-1/4-inches, while a…

For a 3,500 lb hub/drum replacement that will work well to replace your AL-KO 8500 you'd want the hub part #84546UC3-EZ which fits the spindle and has the 5 on 4-1/2 inch bolt pattern you need. For brake assemblies then the Electric Brake…

We no longer have the 22 foot. The longest that we have is the 18 foot long Bargman molded 7-way trailer connector, part #50-67-106, is could be enough for your trailer. It depends on how much, if any, of the existing wire you want to keep and…