Checking Out the Draw-Tite Ball Mount w/ 2" Ball for 2" Hitches Video

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

There is actually no hardware that comes with or is needed to purchase separately for the etrailer Trailer Hitch Receiver #e98901 or its counterpart, the Curt Trailer Hitch Receiver #C13182, both of which fit your 2019 Jeep Grand Cherokee (the only…

For your 2019 Ford Ranger the Draw Tite hitch part #DT73GR is the hitch I recommend over the Curt #C13417 because it has higher towing capacities and it has a bracket built into it for trailer wiring. Aside from that they are very similar and install…

I have some solutions for you, but I'm unaware of a cargo box that will work with a roof rack crossbar system that has a spread of 60"; the good news is that there are some ski racks and cargo baskets that you can use on this system that can…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I'm assuming you're speaking of an anti-rattle device. Many anti-rattle devices depend on the receiver tube to have a lip around it. The Roadmaster #RM-061 or the Brophy #RSCP are examples of this type. An anti-rattle device like the #63232…

We don't have a combo of the Curt Hitch Ball #C40008 and Curt Ball Mount #C45340. The ball mount is extremely heavy-duty, rated up to 17,000 pounds. I think it's safe to assume you don't have a torque wrench rated up to 450 foot pounds…

I recommend the Draw-Tite Max-Frame Trailer Hitch Receiver #76025 for your 2016 Honda Odyssey. This receiver has a concealed cross tube giving you a cleaner, more factory appearance. It is rated for up to 525lbs of tongue weight and 3,500lbs of total…

Yes, the Draw-Tite Ball Mount part #DT49MR comes with a pre-torqued 2" hitch ball as well as a 5/8" diameter hitch pin and clip. It comes ready to go and use.

There is no bolt-on jack made for a round tube trailer frame since this would make securing the jack rather difficult; it would want to rotate around the frame tube whenever it was under load. You will need to have some steel material welded to your…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

There are a couple options for extended ball mounts that fit 2 inch hitches and have extra length for clearance. You didn't mention the rise or drop you need so I'll give you a couple choices so you can find the right one: - 1" Rise,…