Mount: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector on a 2018 Nissan Rogue Video

The difference between load ranges varies based on the tire size and brand. When comparing two tires of the same size and brand, a load range D tire will always have a greater weight capacity and psi rating than a load range C. However, when…

Here's what I'd recommend. If you have an exposed portion of the hitch crossbar to work with, use the #18136 no drill bracket. This fastens to the hitch crossbar using an included pipe clamp. You'll also use the #PK12711U…

A 15x6 inch size wheel is normally interchangeable with a 15x5 size wheel. The 6 inch and 5 inch measurement being the width of the wheel. A tire will normally fit on a range of wheel widths. Where you want to pay attention to the different widths of…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I understand your concern and I don't want to just dismiss it, but the situation you described is not going to happen if you install the Trailer Wiring #118480. If properly route the power wire of this would not wear through. And if that did…

To install the Draw-Tite Activator Brake Controller #5504 that you referenced on your 2018 Nissan Titan you will need the Plug-In Wiring Adapter #3050-P. One end of the adapter plugs into the brake controller itself and the other end will connect…

The Roadmaster Tow Defender Protective Screening #RM-4750 is 100% compatible and will work perfectly with your Blue Ox Aventa LX Tow Bar, as long as you also have Blue Ox base plates already installed on your Mini Cooper. It will do an excellent job…

In order to add lights to your Kuat Sherpa bike rack, I recommend the #C53201 Curt Auxiliary LED Indicator Lights. These lights have a 3M adhesive backing for secure, convenient mounting on a variety of surfaces including your bike rack. Just stick…

Technically you could wire a powered trailer wiring harness such as #C56033 to a separate 12 volt battery. However, without an alternator to maintain the charge of the battery, the trailer lights would drain the battery and you would not know it. It…

The Dexter DX7.5L A-60 Brake Actuator part #DX89FR for disc or part #DX33FR for drum will work to replace both a UFP A-60 or A-75 Brake Actuator so there will be no worried here. The A-60 is rated for 6K and the A-75 is rated for 7.5K. The Dexter…

The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…

The 12-volt trailer feed, which is the pin that sits in the 1:00 position if you're looking at the front face of the 7-way connector on the vehicle is fed by the vehicle battery. If this connection isn't already made on the vehicle side, run…