Installation: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector on a 2011 Nissan Rogue Video

On your 2018 Nissan Rogue, the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector item #HM11143645 has a wire that runs to the battery for 2 reasons. The first and main reason is that there is no other source of constant…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

Class I and class II hitches both have an 1-1/4 x 1-1/4 inch receiver openings. However, a class I hitch has a towing capacity of 2000 lbs and a tongue weight of 200 lbs, a class II hitch has a towing capacity of 3500 lbs and a tongue weight of 300…

The etrailer.com Trailer Hitch Receiver #E98846 that fits your 2017 Nissan Rogue uses M12-1.25 x 35mm hex bolts, which are included with the hitch. I have added a link to a video showing this hitch being installed on a '17 Rogue as well as a link…

We have trailer hitches for your 2018 Nissan Rogue SV like the etrailer.com hitch part #E98846 which has a 3,500 lb trailer weight rating and would be able to possibly tow a very lightweight vehicle. But you'd have to verify that your vehicle…

I was able to find the owner's manual for your 2010 Nissan Rogue and it states that if a trailer is over 1000lbs it will need to have trailer brakes. The maximum towing capacity is 1500lbs if you have manual mode, and 1000lbs if you do not. For…

The find the rise/drop of a ball mount you will measure from the top of the shank to the place where the ball mount platform meets the hitch ball (see attached picture). For example, the Curt Towing Starter Kit #C45534 comes with the hitch ball…

According to the instructions that I have linked below the 5 bolts used are M12-1.25 x 35mm for the etrailer Trailer Hitch Receiver #e98846.

For your 2011 Nissan Rogue the trailer wiring harness part #118480 would be confirmed as a fit and would work well for trailer wiring. I attached an install video for you to check out as well.

It is very odd that only the third brake light on your Rogue would be acting up after installing the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118480; it really should not be possible that only the third brake light is having…

On trailer wiring harness #118480 for your 2013 Nissan Rogue, you will have to connect the power wire from the converter directly to the vehicle battery. No other 12 volt source should be used. It is not recommended to attach the power wire from the…

Your Nissan Rogue doesn't have the correct brake light setup for you to be able to splice in a 4-way in the way you described. Trailer wiring requires the stoplights and blinkers to be on the same circuit whereas your vehicle has separate turn…