bing tracking image

Trailer Wiring Harness Installation - 2011 Dodge Ram

content loading

Customers compare PK11932 to these similar products




Products Featured in this Video



How to Install a Trailer Wiring Harness on a 2011 Dodge Ram


Today on our 2011 Dodge Ram well be installing the Pollak fifth wheel and goose neck connector wiring harness part #: PK11932. First well need to locate a suitable spot for installing the connector in the truck bed. Then Ill take a pilot bit and run it through the bed and double check my location. Were going to go ahead and take a quarter inch bit which will be the same size as my pilot bit for my hole saw and drill out the hole. Now with my hole drilled out well go ahead and take the hole saw and make it large enough for the connector to fit through. With the large hole drilled out we can now take the wiring harness and feed it from underneath through the hole.

Now were ready to go ahead and install our wiring into the back of the connector. Well start with pin number one which is numbered here at the back of the connector which will be our red wire, pin two will be the large white wire, pin three will be our blue wire, pin four will be the green wire, and next Im going to go ahead and do the center pin which is actually pin seven and will be a yellow wire as it will make it easier to install now versus after we do the pins five and six. Pin five is going to be black wire and pin six will be our brown wire. Now with all our wires installed we can go ahead and install the seven pole connector onto the end of our wiring connector and secure it to side of the bed using four self-tapping screws. Next well go ahead underneath the vehicle, rout our wire over to the manufactures seven pole and plug in line with the manufactures wiring.

With that connection made we can go ahead and take some black zip ties to secure our wiring. In just a few simple steps weve gone ahead and completed the install of our Pollak fifth wheel and goose neck connector wiring harness part #: PK11932 on our 2012 Dodge Ram.


Info for this part was:

Employee Jeff D
Installed by:
Jeff D
Employee Joshua S
Video Edited:
Joshua S
Employee Chris R
Video Edited:
Chris R
Employee Nicholas E
Test Fit:
Nicholas E

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.