Today on this 2009 Hyundai Veracruz were going to install part number 118529 from Tow Ready. The first thing were going to do is find the ports to plug our wire harness into. Its located on the left hand side of the vehicle right behind the fender and bumper. What were going to do is pop them loose so we get easier access to the caps, and remove the caps. Next well go ahead and route our wire harness through the bumper structure and down to the ports. Its kind of hard to see, but theres a hole in the bumper structure right in front of the frame rail, so you have to take the wire harness and push into that hole and then out toward the back of the bumper.
Once we have both plugs routed through well go ahead and pull it out and then plug them into the ports. Then well go ahead and reattach them to the original spots. Now well go ahead and clean off a section of the interior on the bumper and well go ahead and mount the module there. Then well also go ahead and run the four pole out to the center of our hitch, and then well go ahead and take up the extra wiring and zip tie it to the hitch. Well take the four poles cap and run it through the safety chain loop and back onto itself.
Thats all it takes to install our wire harness, part number 118529 on this 2009 Hyundai Veracruz.