bing tracking image

Trailer Wiring Harness Installation - 2007 Kia Sportage

content loading

Products Featured in this Video



How to Install a Trailer Wiring Harness on a 2007 Kia Sportage


Today on this 2007 Kia Sportage were going to install part number 118401 from Tow Ready. This wire harness uses a port thats underneath the bumper on the passengers side behind the rear tire. Well remove the cap and install the wiring harness into that connector. To make your install of the wire harness a little bit easier, well loosen up the bumper cover to have better access so we can hide the wires behind the bumper bracket supports. Then well go ahead and route our four pole wire to the center of the hitch. Well actually use a loom clamp to help hold the wires up away, and that will be part number A0500.

Next well go ahead and pull the white wire away from the wire harness a little bit, and well go ahead and attach it to the sheet metal on the vehicle. Then well take our module and well attach it to the hitch using adhesive. Well clean off a spot and then attach it. Well use a couple of zip ties to help secure the wires, and then were finished. With that, that will finish it for our install of part number 118401 from Tow Ready on our 2007 Kia Sportage..


Info for this part was:

Employee Joe V
Test Fit:
Joe V
Employee Randy B
Test Fit:
Randy B
Employee Zack K
Video Edited:
Zack K
Employee Andrew K
Video Edited:
Andrew K
Employee Jacob T
Video Edited:
Jacob T
Employee Kathleen M
Video by:
Kathleen M

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.