bing tracking image

Trailer Wiring Harness Installation - 2007 Honda Pilot

content loading

Customers compare 118336 to these similar products

Products Featured in this Video

How to Install a Trailer Wiring Harness on a 2007 Honda Pilot

Today on this 2007 Honda Pilot were going to be installing Tow-ready T-One 4-Pole Harness part# 118336. Where the back of our Pilot and we need flip up this storage compartment down here. Once we've done that we can begin removing this trim panel along a threshold. Over towards a driver sides near this latch were going to peel back the trim panel just a bit until we find this harness. Take a pry tool and it's just secured with little Christmas tree plastic pin, were just going to popped that out of the body and this what were going to use to connect our T-One harness. You go ahead and separate from the clip, we'll take our harness and snap it in this connector and make sure it's seeded all the way.

Were going to take our wire in our new connection and tuck it back over here closer towards the driver side. Now theres a little pocket form into the sheep metal down here this going to make a nice little home and were going to slide that into that pocket, go ahead and make sure all our wires still tucked in it the trim panel. Theres a little match form down here in our cargo well and that's where we going to run our 4-Pole through. Now were going to take our trim panel and snap it back into place. Make sure that your rubber seals your pole out and our pinch and use your fingers or a small pry tool to pull back out just make sure that you don't tear it.

And our new full blow harness it just going to live inside the cargo well while were not using it. Now go ahead and show you how youre going to set it up when youre ready to use it. Open your cargo well pull full pole harness out and then go ahead and close the cargo well door, now were just going to run this outside of the vehicle and down to our hitch area. You can actually close the hatch of the Pilot on top of the wiring harness because the weather stripping here is going to protect it and pad it from being pinched just make sure that you don't come over to the center were the latch is, if the wire gets caught in the latch it will get pinched and damaged. And that's it for Tow-Ready's T-One wiring harness for the 2007 Honda Pilot part# 118336..

Questions and Comments about this Video

Info for this part was:

Employee Zack K
Video Edited:
Zack K
Employee Andrew K
Video Edited:
Andrew K
Employee Joshua S
Video Edited:
Joshua S
Employee Jacob T
Video Edited:
Jacob T
Employee Andrew L
Video Edited:
Andrew L
Employee Jeff D
Installed by:
Jeff D
Employee Cole B
Installed by:
Cole B
Employee Nicholas E
Test Fit:
Nicholas E
Employee Shane T
Test Fit:
Shane T

At we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.