2014 Audi Q5 Curt Trailer Hitch Receiver: Complete Installation Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The Tekonsha ZCI Vehicle Wiring Harness #119250KIT that you installed on your 2019 Toyota RAV4 can be extremely sensitive with regards to the initial setup. Because it uses zero-contact sensors to identify current flowing through each wire, all the…

The bunk boards on the CE Smith Boat Trailer #CE48810 are actually adjustable so that it can accommodate a wide variety of boat styles. If you check out the picture I attached you can see that a similar boat (might even be the same boat) fits great…

If you currently have a working 4-Way plug then using the 7-Way RV Upgrade Kit for Trailer Brake Controller Installation Kit part #ETBC7 kit is a great way to get a powered 7 Way connector on the rear of your 2014 Audi Q5. You can use the Curt…

As long as the fender is tightly installed on the bike and the hook is attached to the fender as close as possible to the top tube of the bike, the #BA22B should carry the town bike you mentioned with no problem whatsoever. I spoke with one of my…

If you are reading a constant 12 volts on the blue brake output wire with the Curt Venturer Brake Controller #C74VV installed, this is indeed an indication that either the controller itself is bad or there's a short somewhere along the brake…

The Replacement Master Cylinder Assembly #T4395100 will not work to replace your Atwood master cylinder model 85841. Since replacement parts for your actuator are obsolete, your only option is to replace the entire actuator assembly. The Demco…

It sounds like you have free backing braking assemblies on your trailer so a lockout at the trailer coupler is not needed. In order to replace the Atwood Surge Brake Actuator 82541, I recommend using the Titan Leverlock Brake Actuator part…

The Demco Hydraulic Brake Actuator part #DM72VR is a great option to replace an Atwood 82543. That said, it does not come with any sort of reverse lockout feature therefore in order to reverse without the brakes locking up you will either need to add…

Yes we have trailer wiring harnesses that fit your 2014 Audi Q5 like the Curt #C56404 which installs easily by plugging in line with the taillight wiring of the vehicle.

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

Thanks for the kind words, happy we were able to help, and the photos are also appreciated! As for the actuator, you are correct that the Atwood 85736 master cylinder is no longer available because Atwood was bought out so your best option is going…