View Cart

Trailer Hitch Installation - 2013 Dodge Ram - Draw-Tite

content loading



Customers compare 75662 to these similar products




Products Featured in this Video



How to Install a Trailer Hitch on a 2013 Dodge Ram


Today in our 2013 Dodge Ram Pickup we'll be installing the Draw-Tite Hitch part number 75662. Next we'll go ahead and give you a couple of measurements to assist you in selecting accessories for your new hitch such as a ball mount, a bike rack, or cargo carrier. We'll center the hitch pinhole to the outer most edge of the bumper its 3 1/4 inches from the top to the receiver tube opening to the ground is 19 inches. Now, lets go ahead with installation. Note, we've already gone ahead and lower and remove the spare tire for the easy installation of installing the hitch. The first step of our install we'll be removing the cap at the pre drilled point in the bumper.

Now, with the cap remove, we'll uncover our top or rear attachment point. The hardware attachment point will be a 3/4 inch bolt, 3/4 inch conical toothed washer, and 3/4 inch lock nut. We'll go ahead and put our bolt and washer in to place now. Next, we'll move underneath the vehicle where we'll see the forward or lower two attachment points already in the crossbeam or tube of the vehicle. For these two attachment points we'll be using half inch carriage bolted block along with the half inch conical toothed washer and nut.

Pulling our hardware to the tube into position, we'll be using the half inch bolt leaders provided with our install kit. Lets go ahead and put the hitch up in the position taking the 3/4 inch nut and placing it between the hitch so that we can thread it onto the bolt. Next, we'll make sure that the forward or lower attachment are lined up with the hitch and the cross tube. Then we can take our pull wire feed it to the attachment point and out the end of the cross tube. Next we'll slide on the block and thread on the carriage bolt. We'll go ahead and slide both of them into tube and pull them in to the position.

Once in the position we can remove the bolt leader, slide on our conical toothed washer and thread on the nut. Now, we'll go ahead and repeat the same process on the other side. With all our hardware in place, we'll go ahead and tighten it down and torque to specifications as indicated in the instructions. Now, they're tightened and torqued to specifications we'll go ahead and install the new cap over the 3/4 inch bolt provided with our install kit. Now, with everything installed that will complete the installation of our Draw-Tite Hitch part number 75662 on our 2013 Dodge Ram Pickup.


Questions and Comments about this Video

add comment

Info for this part was:

Test Fit:
Joe V
Video Edited:
Zack K
Video Edited:
Andrew K
Video Edited:
Joshua S
Test Fit:
Nicholas E
Video Edited:
Jacob T
Video by:
Patrick B
Video by:
Kathleen M
Test Fit:
Randy B
Video Edited:
Chris R
Test Fit:
Jared G
Video by:
Zach D
Test Fit:
Brent H
Video by:
Jonathan Y
Test Fit:
Robert C

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.