Hopkins 4-Pole Flat Plug-In Simple Vehicle Wiring Installation - 2013 Honda Odyssey Video

From the top of the Draw-Tite Max-Frame Trailer Hitch Receiver #75270, when installed on your 2007 Honda Odyssey, to the ground is going to be approximately 12-3/4". Adding on a 350lb wheelchair and 55lb carrier #FHG67ZR is definitely going to…

The Curt T-Connector Vehicle Wiring Harness #C56378 did not have compatibility with a backup camera when the video was made. You can see in that video that it lacks the additional connection with the white wire that it now comes with. This was added…

To install the etrailer Trailer Hitch #e98862 on your 2016 Honda Odyssey you will put the brackets of the hitch over the flanges you're talking about. Once you torque down the hardware the hitch will be secured to the frame of your vehicle and…

Basically a lot depends on what you will be using the hitch for. If it is just for accessories such as a bike rack or cargo carrier than for the most part you will be fine with a Class II trailer hitch. If you will be towing then I would go with the…

In order to install the Draw-Tite Max-Frame Trailer Hitch Receiver part #76025 on a 2014 Honda Odyssey you"ll need to trim the fascia in the center to allow the receiver tube opening to pass through and above the tail pipe. The reason you must…

Curt decided not to design hitch #C13068 to account for those welded on pieces you referenced in order to maximize the size of the side hitch brackets. As to why they chose to go with a 5 bolt design I can't say. The Draw-Tite hitch #75270 sounds…

In order to find the correct amount of rise/drop to look for in a ball mount you simply need to measure the distance from the ground to the bottom of the trailer coupler while level and then from the ground to the top inside edge of the receiver on…

Yes. Because the Hopkins Plug-In Simple #HM11143114 is a plug and play wiring harness which required no hard wiring, a bad or insufficient ground wire on the trailer is the most likely cause of the trailer lights not working when the head lights on…

From what little I was able to learn about the VelociRAX 5 bike rack on their website, the rack is compatible with a 2 inch hitch that has a tongue weight capacity of at least 500 lbs, and the Draw-Tite #75270 Class III hitch meets both those…

The best way to determine which transmission line is the high-pressure or supply line and which is the return line is to start the motor cold. Place the transmission in drive for 10 seconds and return it to park. Turn off the motor and feel both…

Ideally you'd run a second cooler after your factory cooler but based on your cooler being separate from the radiator and more or less similar to a supplemental cooler if I were you I'd replace it with something larger and more efficient like…

The Derale Series 8000 Plate-Fin Transmission Cooler Kit #D13501 will absolutely fit your 2017 Chevy Colorado without any type of 90 degree adapters. The key is just ensuring the correct length of hose; that is a pretty open area so you will have…