Today on our 2013 Dodge Durango well be test fitting the Hollywood Racks Traveler five bike carrier, part number HR9200. To begin our test fit well slide the shank of the carrier into the opening of the hitch, line up our pin holes, thread our anti-rattle bolt through the pin holes and tighten with a wrench. Now well go ahead and go over a few measurements to see how the bike carrier and this vehicle will fit together. Theres about 13 inches of ground clearance. The closest part of the carrier to the closest part of the vehicle here at the rear bumper is about 11 inches. With the cradle arms folded down weve added about 13 inches to the overall length of the vehicle.
Now well loosen up the knobs on the left and right hand side of the carrier to swing the cradle arms out, and well measure from the cargo door to the end of the cradle arms, and we get a measurement of 43 inches. To access the cargo area, pull the pin at the bottom of the mast and tilt the carrier down. This will allow us to have access to our cargo door. To load the bike well make sure that the mast is in its upright position. Well undo the cradle straps, set the bike into the frame cradles and secure it with the straps That completes todays test fit for the Hollywood Racks traveler five bike carrier, part number HR9200 on our 2013 Dodge Durango..