Convert-A-Ball Ball Mount with 8 Inch Drop Review - 2008 Toyota Tundra
Customers compare AMSC8 to these similar products
Products Featured in this Video
Review of the Convert-A-Ball Ball Mount with 8 Inch Drop on a 2008 Toyota Tundra
Today on our 2008 Toyota Tundra will be tested in the Covert-A-Ball Cushioned Ball Mount for 2-inch hitches with a 6-3/4 inch rise or an 8-inch drop rated at 10,000 lbs, Part #AMSC8. To begin our test fit we first need to get our hitch height; this is the measurement from the ground to the inside top edge of our receiver tube. We have a hitch height of 19-1/4 inches. We'll now take our ball mount and install it in the drop position. We'll slide the shank of our ball mount into the receiver tube of the hitch, line up our pin hole, and install our pin and clip. We'll now take a measurement from the ground to the top of our ball platform. We have a measurement of about 11 inches. When measuring your trailer height you want to measure it when your trailer is level. You'll measure from the ground to the bottom of your coupler. If your measurement matches ours, then this would be a good fit for you. We'll flip it over to the rise position, and we now have a measurement of 25-3/4 inches. Again, if your measurement matches ours, this would be a good fit for you. And that completes today's test fit for the Covert-A-Ball Cushioned Ball Mount for 2-inch hitches, Part #AMSC8 on our 2008 Toyota Tundra.
.
Info for this part was:
Test Fit:
Patrick B
Test Fit:
Rick A
Test Fit:
Matthew K
Test Fit:
Cole B
Test Fit:
Randy B
Video Edited:
Joshua S
Video Edited:
Jacob T
Video Edited:
Kathleen M
Video Edited:
Dustin K
Video Edited:
Sue W
Installed by:
Hayden R
Video by:
Zach D
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.