Bully Dog Triple Dog Performance Chip Installation - 2005 Dodge Ram

content loading




How to Install a Bully Dog Triple Dog Performance Chip on a 2005 Dodge Ram


Today on our 2005 Dodge Ram with the 5.9 Cummins Diesel well be installing the Bully Dog Triple Dog GT Gauge Tuner part number BY40420D. Now this performance chip will boost the power up whatever your vehicles diesel engine as well as monitor and diagnose all in one. Youll be able to get gains and horsepower and torque. The unique driving coach program helps you maximize fuel economy. Now to begin our installation, well need to run our power wire. Well run it through the firewall here in this grommet where this cable passes through.

Now that were out here in our engine compartment, well run it up and out of the way following our factory harness to the fuse panel here. Now that we found the fuse, it powers up when the key is turned on, well use our inline fuse circuit tap kit part number F2526. Well remove the fuse, install the two fuses into the fuse holder and reinstall the holder into the fuse location that will enable this wire here coming out of our fuse block to be energized. We can then connect the power wire for our Bully Dog programmer to it. With that done, well simply take off the excess wire here in the engine compartment leaving enough wire to plug in to our DLC3 connector here under the dash.

Well then route it up towards the top of the dash. Well use the suction cup mount to mount the program or monitor in place. We can attach our bully dog programmer monitor into the other side. Now, with our monitor in place, were now ready to turn our key to the on position. Youll notice the Bully Dog programmer then comes on.

It will walk you through downloading the programming to the vehicle. That completes our installation of the Bully Dog Triple Dog GT Gauge Tuner with colored screen part number BY40420D on our 2005 Dodge Ram with 5.9 Liter Cummins Diesel.


Questions and Comments about this Video

add comment