Manufacturer Interaction - Torklift Glowstep Revolution Video

It sounds like you are looking for the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear - 2 Steps - 25-7/16" Base - 350 lbs #TLA8102. The mounting base dimensions are 25-7/16" wide x 12" deep. I reached out to my contact at…

I recommend the TorkLift GlowStep Revolution Scissor Step #TLA8102 for the biggest improvement in stability and comfort on your Aspen Trail. This USA-made steel and aluminum 2-step unit is compatible with your mounting brackets and your 26-inch…

The TorkLift GlowStep Revolution Scissor Steps part #TLA8102 attach using 3/8" hardware so you'll need a .375" hole to secure them. The step brackets install into outrigger brackets already on the trailer under the door. I have attached…

The GlowStep Stow N' Go steps #TLA7833 have a bolt-on mounting base that installs on the outside of your camper. The base provides a strong and stable connection to your camper, and it attaches permanently using the included mounting hardware.…

You are correct that the TorkLift GlowStep Revolution Vertical Stud Adapter Bracket #TLA8022 you were looking at will bolt to the frame of your 2020 Jayco Whitehawk 24MBH and then to the underside of your door sill. I attached a few photos of the…

Since you don't have the rails under your slide out the typical slide out supports like part #UF19-960003 wont' work but we do have another possible solution for you. Brophy has some camper jacks that are meant to be used for supporting a…

Thanks for reaching out, Edith! Yes, the TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear #TLA8102 are exactly what you need for your 2021 Lance 1995 according to the specs you gave me.

The TorkLift GlowStep Revolution Scissor Steps w/ Landing Gear #TLA8102 have a height of 16-1/2" from the top of the mounting bracket to the bottom of the steps when fully retracted. This is the same for the #TLA8103 since they both use the same…

The Torklift Glowstep Revolution Scissor Steps #TLA8102 would be the correct fit for your 2021 Lance model 1995 travel trailer if your entry height was between 18-1/2" to 28" and you had room for the mounting bracket width of 25-1/2…

The steps we carry that are the closest to your mounting hole measurements are the Flexco Manual Pull-Out Steps #SMFP-2120. The mounting holes are 20-1/2 by 7 inches. Unfortunately, there aren't any steps that we carry that are exactly the same…

You would need to support the Rail Kit for Kwikee SuperSlide II RV Storage Slide Out Tray Assembly #LC370762 the entire length and would not want to cantilever over the 8" drop. To complete the tray you'll need to choose the appropriate size…

Lippert didn't have the dimensions for how far out the Rail Kit for Kwikee SuperSlide II RV Storage Slide Out Tray Assembly #LC370762 extends in either direction so I had one pulled from stock and did a bit of testing. On one end of the assembly…