A Closer Look at the Trailer Axle with Idler Hubs Video

Hey Troy, thanks for reaching out. We actually get this question fairly frequently since a lot of older trailers used "shorter" hubs compared to the current standard. I am sorry to say that we do not offer any hubs to fit this type of…

Hey Bob! The CE Smith Trailer Axle Beam with Studded Hubs #CES84XR will fit your 1988 NuWay trailer if your current axle has 49" hub face and 38-1/2" spring center dimensions (see attached photo to compare). The overall beam length is…

Hey Gary, so the holes that are on the CE Smith trailer axle part #CES84XR are currently at 38-1/2 inch on center so there would easily be enough room to put new ones at just 3/4 of an inch past where they are now but you would need to rotate the…

Hey Nate, I can definitely help and point you in the right direction. For the axle, I will need to know the weight capacity, hub face (HF) length and spring center (SC) length. There should be a tag or sticker on the axle that has this info, unless…

Hey Andrew, The CE Smith Trailer Axle Beam with Studded Hubs #CES84XR is a 1-1/2 inch square axle tube.

The Kodiak Wheel Bolt #K12WB169 that you referenced should fit just fine. Since all of the differences are small fractions of an inch you are good to go!

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

The Trailer Axle with Idler Hubs #e84YR shows for 8-12" wheels as once move up to larger diameter wheels you move into weight ratings that are much higher than the axle rating. Having wheels and tires with higher weight capacities means that the…

The correct replacement leaf springs for a Malone MicroSport Trailer part #MPG460G are the 2-Leaf Slipper Springs part #e36SR. These will be a direct fit replacement for the old springs. They are slipper springs with a 500 lb weight capacity that…

There will be 54" between the backs of two of the Dexstar Steel Mini Mod Trailer Wheel item #AM20365 when installed on the 60" Trailer Axle with Idler Hubs item #e84YR. This is without the tires so when you add rubber to the item #AM20365…

Bearing 07100 are older bearings with the same dimensions as bearing #L44643. The spindles that uses those inner and outer bearings are #TRU94FR and #TRU59FR. The difference between these is one measurement, the furthest outer diameter, which is…

The EZ Lube Spindle #TRU37FR that you mentioned is to be welded onto an axle tube. If you were to install it directly to your trailer frame the capacity would be greatly reduced not to mention unknown. Also, the ride with no suspension would be…