Review of the Trailer Hub and Drum Assembly Video

We do have the correct replacement hub and drum for your Dexter 8-249, and there are a couple of options. The only thing that separates them is if you have an E-Z Lube axle (your spindle will have a grease zerk) and what your hub's bolt pattern…

The Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 5-1/2 #AKHD-555-35-K will fit the spindle on your trailer to replace your AL-KO 8700 hub, but this does have a 5 on 5-1/2" bolt pattern. My information is the AL-KO…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

I can see in your attached picture that your tire size is ST205/75-14 which is a very common size and would mean that you would need a 14 inch trailer wheel with a 5 on 4-1/2 inch bolt pattern like the Aluminum Liger Wheel part #LH84FR or any of the…

We sure do! The etrailer Electric Trailer Brakes item #AKEBRK-35 work with 3,500 lbs axles that have a 4 bolt mounting flange. These left and right 10" x 2-1/4" assemblies have rust-resistant, e-coated backing plates that work with 15"…

Sorry Fred I can not. The thickest tape I have with 1-1/2" width is 1/8" thick. It is Alpha Systems QTDG Tape for RV Weatherproofing item #AL78FJ which is dark gray and 30' long.

For the tire size ST225/75-15 in the Load Range D like the part #274-000029 the weight capacity is 2,540 lbs at 65 psi. Which with just four of these you'd be over the 10k GVWR of the trailer you mentioned so you should be fine.

We do have one option available for you, but the #AKUBRK-35 are not the correct solution for this. You're looking for the Dexter Electric Trailer Brake Kit - 10" - Left and Right Hand Assemblies - 3,000 lbs #K23-472-473-00, which are an…

At this time we have not had he chance to video a brake controller installation on a 1996 Ford Bronco. I do have some information that will be helpful though. If your Bronco has a factory 7-Way connector at the rear of the vehicle or if you have a…

You can refer to the linked photo that shows how to measure both the diameter and depth of a boat trailer hub/drum. When selecting new hubs there are several characteristics you need to match up to ensure compatibility. Those are weight rating (to…

From our experience the Ranger Trail Boat Trailers like your 2003 Ranger Trail R61 use inner bearing #L68149 and outer bearing #L44649 but you will want to confirm this by verifying which inner and outer bearings your trailer uses. You can determine…

I definitely understand your desire to have a light weight 5th wheel trailer hitch that you can easily take in and out of the bed of your 2020 Chevy Silverado 3500. Part of the benefit of those factory pucks is the completely clean bed it allows once…