bing tracking image

Review of etrailer Trailer Fenders - Single Axle Slant Back Fender - HP98VR

content loading

Customers compare HP98VR to these similar products




Products Featured in this Video



etrailer Trailer Fenders - Single Axle Slant Back Fender - HP98VR Review


Ellen: Hey everybody. I'm Ellen here at etrailer.com. We're going to be taking a quick look at the single axle trailer fender. This helps to protect other drivers from any rocks or mud or anything getting slung up at them. It also helps to protect the gear on your trailer from the same. You don't have to worry about any debris getting deflected or slung up underneath those tires onto your equipment, your vehicles, or anything else that you might be towing on your trailer.This is a slant back design.

A lot of times these will be used on a marine style trailer or a boat trailer. It should match up with the side of your trailer. As you can see, it's going to have a little bit of a taper at the bottom compared to the top. It's just a little bit more flared down here than it is up at the top or the apex of that fender. It is made out of a 16 gauge electro polished stainless steel.

It looks really nice and shiny, pretty much rustproof as well. It does have a PVC coating on it to protect it from any kind of scratches.It is a weld on or bolt-on installation. It does not have any pre-drilled holes, although there are a couple holes here. There's one at the very top. Then two on either side.

You might not end up being able to use those though. You might have to drill more holes into that to actually get it installed. The mounting brackets for a bolt-on installation would be sold separately, but you can also weld it as well.The outer edge here does have a one inch diameter curved radius, so it gives it a nice finished look. The length from outside edge to outside edge of our fender is 30 inches. Then it stands 13 inches tall.

It does just come as a single fender, so you'll need to get one for either side. It weighs about eight pounds. It's covered by a one-year limited warranty, and it is made in the USA.That really about does it for our look at the single axle trailer fender. I hope this has been helpful in deciding if it's the right one for you. We do have a lot of other options available here at etrailer.com. Check them out. Thanks for watching.


Questions and Comments about this Video

Info for this part was:

Employee Kathleen M
Installed by:
Kathleen M

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.