The Low-Down on the Ratchet Tie Down Straps w/ Storage Bag Video

Hey Will, the interior dimensions of the etrailer enclosed cargo carrier part #C63ZJ is 60 inch wide, 24 inches deep, and 30 inches tall.

Your 285 series tire is approximately 11.22" wide, so a wheel lock for up to 12" wide tires, like the Club Tire Claw XL Wheel Lock with Lug Nut Protector Plate, part #WI491KA-491LNP that you were looking at should work for you, since the…

I spoke with my contact at CE Smith regarding the Fold-Up Wheel Chocks #CE32600 referenced in your question. She stated that these do not actually have a listed weight capacity, as they are designed and sturdy enough to be used on any RV or trailer…

Many RV bumper manufacturers construct their product with a plastic cap or a hinged door instead of endcap, allowing bumper to be used for storage; apparently you have this type. Open that end piece to examine if the seam has spot welds (short welds…

I recommend using the Lockrack Adjustable XL Watersport Carrier #LR54FR to carry you canoe on the roof of your 2019 Dodge Grand Caravan GT. This will allow you to use your factory cross bars that are only 37" wide to carry your kayak as there is…

We likely have a toolbox which will work with your Aluma 548 trailer although A-Frame toolboxes are not made specifically to fit certain trailers so you will need to know the amount of room you have to fit the box. I do recommend going with a plastic…

The Gen-Y Iron Grip Anti-Rattle Hitch Pin #GY49FR (part GH-023 you mentioned) is designed for solid shanks but the XL Anti-Rattle Trailer Hitch Receiver Lock for 2-1/2" Hitches #SHP2040-XL uses that block that sits inside a hollow shank so the…

This is an excellent question and the answer is you can use a bike rack at the rear of your 2014 Honda CR-V, it simply needs to be rated for use behind a flat towed vehicle. The reason for that is the larger amount of movement and shaking that occurs…

The brackets part #LC373965 that you referenced basically either bolt around or weld to the bumper support beam on the RV. I attached a picture that shows them welded but you could also drill holes in the bumper and use included hardware to secure…

Since you do not have the 4" of clearance to mount the Installation Hardware #LC373965 for the Lippert Components Flip Down Slotted Bike Rack Tailgate Storage System #LC243621, you will need the Lippert Tailgate Storage System Mounting Kit -…

Once installed to a 4 or 4-1/2 inch continuously welded steel bumper, the Swagman RV Bumper Bike Rack would extend 19 inches beyond the bumper. The first bike wheel would sit 6-1/2 inches rearward of the bumper. If you take some measurements to…

The first bike sits 6-1/4 inches from the rear most part of the bumper. Then another couple of inches to the center of the first wheel cradle. And you would have to add the width of the bumper and the distance, if any, from the forward edge of the…