Review of Westin Nerf Bars - Running Boards Replacement Hardware - 25-168PK Video

The correct replacement mounting brackets and hardware for your 2004 Chevrolet 2500 HD with the extended cab are dependent on which Westin 3 inch nerf bars you have. The brackets and hardware are custom to the truck as well as the nerf bars. Use…

Thanks for the photos and information! I confirmed with my contact at Westin that you need Replacement Hardware for Westin Signature Series 3" and Platinum Series Round Step Bars #25-168PK. This fits the Westin Signature Series Round Nerf Bars -…

I contacted Westin and the correct replacement bracket kit for the 3" round platinum series nerf bars on your 2007 GMC Sierra 2500HD DuraMax Diesel Extended Cab 4dr is the Replacement Hardware for Westin Signature Series 3" and Platinum…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Mike, I believe you are asking about the height of just the blue spring of the part ##SS68DR SSR-623-40 which is 4 inches. Otherwise it sounds like you are asking about the distance from the top of the mounting bracket to the bottom of the spring…

With Curt Trailer Hitch Receiver #C15302 installed on a 2003 Chevy Silverado 2500 short bed the hitch will be in the same position as a factory hitch or at least within a fraction of an inch. By that I mean the receiver will be right under the rear…

Curt Trailer Hitch Receiver #C15703 hangs pretty low on a 2005 Chevy Silverado 2500. From the bottom of the bumper to the top of the hitch receiver it is approximately 4 inches. I have included a picture showing the gap. A similar hitch, #C15302,…

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

There are quite a few holes on the frame of your 2002 Chevy Silverado 2500HD short bed that hitches can attach to like the Curt you mentioned part #C15302. This is why the hitch fits for your truck have a few different bolt hole variations. I…