UWS Angled Truck Bed Toolbox Review Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The SumoSprings Solo Helper Springs #SS62XR you were looking at for your 2021 Jeep Gladiator measure in at 5-1/2" tall and 3-3/8" wide as shown in the included diagram. I included a video review of the #SS62XR for you to take a look at.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Hello Carol, welcome back. It is possible to use the Yakima HD Crossbars #Y01157 on your 2025 Subaru Outback Wilderness with the fixed raised bars. What you will need is the TimberLine Towers #Y33TR and the HD Bar Adapter #Y03541 to complete this…

The TireMinder i10 TPMS for RVs and Trailers part #TM56FR will monitor up to 20 tires at once, swapping every 6 seconds between the towing vehicle and trailer. The front and rear sections have a maximum tire amount of 10 so it will work just fine…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

There are few differences between the Draw-Tite Front Mount Trailer Hitch Receiver #65067 and Curt Front Mount Trailer Hitch Receiver #C31083 that fit your 2020 Ford F-150, with the main difference being ground clearance. The Curt hitch does have…

To get the replacement hardware for the Draw-Tite Receiver #65070 you will need to order the Replacement Hardware Kit #RHK and type the hitch item number on the line provided.

Draw-Tite front-mount hitch #65070 is a confirmed fit on your 2012 Toyota Tacoma 4WD. We have not had a chance to install this particular item nor the Curt equivalent #31313 on your same truck so for purposes of seeing the effect on your ground…

Normally the skid plate can reinstall after the front hitch part #31313 is installed but on the TRD models the skid plate is different and can't be.

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…