A Closer Look at the Center Hanger for TruRyde Equalizer Video

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

Triple-axle trailers can show the effects of "scrubbing" especially on the rear axle since when the trailer turns the front axle wheels are the pivot point and the center and especially rear axles will be "pulled along for the…

The Dexter Axle 7-Leaf Slipper Spring w/ Hook End for 8,000-lb Trailer Axles, #DX73QR is 26-5/8" long overall and to the center of bolt is 11-1/2".

You will want to use a 1" diameter wet center equalizer bolt like #7-136-2-6-112 which inserts in the center hole and bolts to the hanger. I have attached a helpful article about the Slipper Spring Trailer Suspension System. The equalizer…

The exact axle spacing will depend on the hanger kit and leaf springs you are using. For example, for a trailer with two 5,000 lb axles, we recommend using hanger kit, #APT6SE, and 4-Leaf Slipper Springs for 5,000 lb Axles, #SP-231275. The spring…

The Center Hanger for TruRyde Equalizer #TRHG291-C is specifically designed to be used with the Equalizer for 2" Wide Slipper Springs #TREQ4541. This is designed to work with trailer axles from 6,000-8,000lbs. The Redline Center Hanger for…

First you would want to jack up the trailer frame and then use jack stands to support it so that you can lower the jack and the wheels will be off of the ground. Next you will want to slide the jack under the first axle so that you can raise it up to…

The 15,172-lb unloaded weight of the Forest River triple-axle toy hauler 395AMP is potentially getting pretty close to your Silverado 2500's towing limit by the time the trailer is loaded up, so the first thing I suggest is making sure the…

Based on your previous order, you will want the Wet Equalizer Bolt with Castle Nut and Grease Zerk - 4-11/16" Long - 7/8" Diameter #TRFA71063. This is compatible with the center #29-5-1.

For a 7/8 inch bolt to use with the #TREQ4541 we only have the part #TRFA71063 which is 4-11/16 inches in length. It may seem a little long but it would still work well. The wet bolts are just as strong as the non-wet bolts we carry.

The Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs #AP216-H238 you referenced is a good option, alternatively, the Torflex Lift Kit #K71-724-02 is another option that is compatible with #11 Torflex axles with 4,100-6,000-lb capacity; And…

Slipper springs are pretty common on tandem axle trailers with heavy duty axles like yours, and I recommend sticking with them as there are limited double eye springs for axles 5200lb+ like yours. The Tandem-Axle Trailer Hanger Kit for 2"…