Let’s Check Out the Bearing Kit, LM67048/25580 Bearings, GS-2125DL Seal Video

The Dexter hub you referenced, 8-201, is a 5,200 lb hub, though a 5 on 4-1/2 bolt pattern does not come on 5,200 lb hubs. The correct bearings for the 5,200 lb hub are #25580 and #LM67048, while the proper races are #25520 and #LM67010. I have…

Most RV manufacturers don't keep a record of the original parts they use when it comes to suspension which is why it is a pain to figure out sometimes (as you have experienced). While I don't have a specific part number I can tell you will…

The 5-Leaf Double-Eye Spring for 6,000-lb Trailer Axles part #e34SR would be perfect for you as the extra capacity means the trailer won't sag as much and the extra leaf will give you more tire clearance. This spring also has a 25-1/4" eye…

Thanks for the additional information! It is always recommended to replace all your leaf springs at the same time so with this in mind you will want the 5-Leaf Double-Eye Spring item #e34SR. These are 6,000 lbs capacity springs with 5 leafs. From…

The bearing kit you are looking for is the part #BK3-310. This includes the bearings and seals you mentioned so it would be exactly what you need.

I think you are going in the right direction. I would definitely replace the 14 gauge wire going to the trailer brake magnets with 10 gauge wire or larger. Usually larger than 10 gauge is hard to get into the trailer connector though. I would also…

I can certainly point you in the right direction. This will be a tricky one, as the Dexter 5,200 lb axles can use more than one seal size. We do not have the ability to pull an OEM build sheets to see what parts they installed at the factory so we…

We offer three grease seals that have a 1.750-inch inner diameter. You can see these by clicking on the link provided. The three seals have outer diameters of 2.312, 2.356 and 2.722-inches. You can use a digital caliper like #PTW80157 to measure your…

In the image with the suspension setup the equalizer #TREQ105 is placed between the front and second axles. Just like you have on your trailer. The front of the equalizer connects to the spring using a shackle strap and the rear is connected directly…

Thank you for all of that excellent information and photos! To replace the front equalizer you need the Curved Equalizer #TREQ104 and then for the rear equalizer you need the Equalizer for 1-3/4" Wide Double-Eye Springs #TREQ105. To replace your…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

If you can read me the serial number on the axle I can then call the manufacturer, Dexter, and find out the weight capacity but if not you can measure the diameter and use the chart below to determine axle capacity. The "P16" is the plant…