In-Depth Review of the Trailer Valet JXC Trailer Jack w/ Footplate and Drill Powered Option Video

?The distance from the mounting plate to the foot on the Trailer Valet JX-2K #TV54FR is 13" when fully retracted. The distance from the mounting plate to the top of the jack is 23". This jack can provide you with up to 14" of lift on…

Patrick, a green coffee pot no, unfortunately. We do have the GSI Outdoors Camping Coffee Percolator #GSI28MV which has a 6 cup capacity but is stainless steel, or, we have the GSI Outdoors Camping Coffee Percolator #37325254 which is green, but has…

The Lippert Power Stance Electric Trailer Jack #LC89VR does not have a drop leg. The pin you see by the footplate is only for the footplate to remove and install it. The retraction and extension of the leg is electronically controlled. If you're…

To verify that the Trailer Valet JXC Trailer Jack #TV54FR will fit your 2018 Nucamp Tab400 you will need to verify that the opening for the a-frame jack on your Tab has at least a 2-1/4" opening. The JX2#TV54FR is enough for your Tab as the…

Yes, the Drop Leg for etrailer and Ram Jacks - 13-1/4" Tall - 5-1/4" Diameter Footplate - Zinc, part #JF-1005H-Z, is compatible with Round A-Frame Trailer Jack - Topwind - 14-1/4" Lift - 2,000 lbs, part #TJA-2001-B. I have included a…

The fully extended length of the #TJ01RT-HD stabilizer jack would be 18 inches, which represents the 'A' Dimension in your photo. The 'B' dimension would simply be the height above the ground of the underside of your trailer when its…

I went out to our warehouse and got the following dimensions for the Stabilizer Jacks #TJ01RT-HD in the stowed position. I have included an image below so you can see the points I measured from. The overall length is 12-3/8" long, 4-3/8"…

There many possible ways to mount a stabilizer jack such as the #TJ01RT-HD you looked at. Mounting them in the orientation shown the diagram would tend to work a bit better to stabilize the trailer against side to side movement, while having the…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The Trailer Valet JXC Trailer Jack #TV54FR that you referenced does not have a drop leg. I attached a picture that shows the jack full extended and you can see there isn't a drop leg. I also attached a review video for more info on this as well.

Yes, the vast majority of a-frame trailer jacks use the same bolt pattern which is 3" apart on center. Therefore you should have no problems whatsoever using an electric a-frame trailer jack on your T@B 320 S teardrop camper. For this, I…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…