TorkLift Camper Tie-Downs TLA7016 Review Video

To connect your Nissan's 7-Way connector to a 4-flat you'll want to use the Pollak 7 Pole to 4 Way Connector Adapter item #PK12716.

In order to satisfy Curt warranty requirements, any of their Class I or II receivers (like the C11423 you referenced) as well as a few of their Class III hitches must be used with a stabilizing strap like part #18050. This applies to any non-trailer…

Yes, the Brophy Clamp On Camper Tie-Downs Item #HSWB and the Brophy Basic Turnbuckles Item #TDHP are not only safe for use on your 2020 Ford F-250, they are a confirmed fit.

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

If you have already added the fuse and the trailer charge circuit is not activated in the 2019 Ford F-350 Super Duty with factory integrated brake controller, then you want to make sure the trailer is connected and you press the brake according to a…

The wiring on your 2019 Ford F-250 Super Duty is a little goofy and it's something that a LOT of people have complained about with the newer Ford pickups. To get power back to your trailer jack you'll have to close your driver's door,…

Correct, the TorkLift SuperHitch Magnum Trailer Hitch Receiver part #TL74FR which is a fit for 2021 GMC Sierra 3500 does require the bolts to the bed be loosened. That said, it actually is not that bad. They won't be removed fully either. I have…

It sounds like you want to install the TorkLift SuperHitch Magnum #TL74FR on your 2023 Silverado 3500 and then add a TorkLift extension. Regarding the installation of the hitch, standard tools along with a floor jack and torque wrench capable of 140…

Thanks for the picture! I would definitely go with one of the HD kits over the 2,000 lbs RoadActive item #RAS3611 you were looking at. Which one you will need is going to depend on whether or not your 2020 Chevy Silverado 2500HD has the factory…

If your 2007 Ford F-350 has the 8 foot bed, is equipped with the factory trailer hitch, and doesn't have a board or step beneath the truck bed, the correct TorkLift Rear Tie-Down Kit is part #TLF3004 or #TLF3004A for the aluminum model that will…

The cover I recommend for your Northern lite Camper is the Camco UltraGuard Slide-In Camper Cover, part #CAM45773. This cover fits campers up to 19-ft 6-inches long overall. This should give you room for the ladder you said you have on your camper.…

Sounds like you have an auto leveling Lippert Ground Control/Level Up jack kit on your trailer. Yes, the JT Strong Arm Stabilizer System #LC191023 will work with your LCI Level Up System. I checked with Lippert and found that you can use the JT's…