Titan Trailer Hubs and Drums - Hub with Integrated Drum - T1544600042 Review

content loading




Review of Titan Trailer Hubs and Drums T1544600042


Today we are going to review part number T1544600042. This is the Titan trailer hub and drum assembly for 3500 pound axles with the 5 on 4 1/2 inch bolt pattern. Now this trailer hub and drum assembly will fit on axles that have an electric or hydraulic brakes. It does include everything show in here, the bearings, the races which are pre-installed into the drum, the double lip grease seal, the grease cap and the lug nuts and again basically this application is for 3500 pound axles with electric or hydraulic brakes. The drum dimension is measured on the inside via 10 inch diameter and a two and a quarter inch width. Basically just to show you where that measurement is taken, we do the inside to inside diameter, that is going to be right at 10 inches and then again the width, we'll just measure the width across and we can see it's right at two and a quarter inches. Basically this will fit on brake assemblies that are listed as a 10 by two and a quarter inch brake assembly.

The bolt pattern on this is 5 lugs 4 1/2 inch bolt pattern. The wheel stud themselves are half inch diameter. Now the bearings it comes with. The larger bearing which is the inner bearing is part number L68149 and this will install, you see the pre-installed inner bearing race that will install right in there and then you take your double lip grease seal. You put that up there and you tap that into place it seal that and then on the very front, the smaller bearing is the outer bearing, it's part number L44649 and again it has the pre-installed race that the bearing would just sit in and then once you slide this through your spindle will come through. Put your lock washer or your washer in your nut on there, tighten it all down and then you have your grease cap that you just tight or tap in to seal that and then you'll be ready to go. Then it also comes with the 5 1/2 inch log nuts that once this is all installed on your axle and you are going to go ahead and put your wheel and tire assembly back up on here, then you'll take your 1/2 inch log nuts and just use those to tighten that wheel and tire assembly onto your axle and then torque it to the correct specs.

But that should do it for the review on part number T1544600042, the Titan trailer hub and drum assembly for 3500 pound axles with a 5 on 4 1/2 inch bolt pattern. .


Questions and Comments about this Video

add comment