Review of Swagman RV and Camper Hitch - Bumper Mount Hitch - S64025

content loading

Customers compare S64025 to these similar products




Products Featured in this Video



Swagman RV and Camper Hitch - Bumper Mount Hitch - S64025 Review


Today we're taking a log at a Swagman RV bumper, two inch trailer hitch receiver. This unit adds a two inch hitch to your RV, that way you can load up your bike rack and your bikes and take them along with you on your adventure.Now this is a solid steel construction. Nice powder coated finish to resist rust and corrosion. I do have it mounted to a block that way you can kind of see how it would wrap around an RV bumper.It comes with all the necessary hardware for installation. This is for use with up to a four bike, non-folding, standard bike rack. It comes with the anti-rattle screw or bolt which can be tightened against the shank of your accessory to reduce rattle and movement from within the hitch.

Please keep in mind, this is not to be used for towing or to be used with cargo carriers. It's for use above the bumper only.When using this, you want to be sure that you never exceed the bumper stated capacities. It's a simple attachment. No drill installation. Simply bolts on to your RV's bumper using the included hardware.

Now this is designed for a four inch by four inch, and four and a half inch by four and a half inch continuous welded steel bumpers. It's not for use on aluminum or spot welded bumpers, so please keep that in mind.The unit has a load capacity of 200 pounds. Few measurements I want to go over with you real quick. You can see right here at the center we have our standard five eighths diameter pin hole, which is the pin hole we use to secure our accessory inside our receiver tube. From the center of that pin hole to either end of the receiver hitch, we have three inches.

So center to this end is three inches. Center to this end is three inches. The overall measurement we get, it's about six inches. That's the same as our mounting plate, so our mounting plates are six inch square measurement. Six inches by six inches.Overall it's a nice design.

Again no drill, bolt on installation, and it comes with that anti rattle screw, as well as mounting plate, and everything you need for your install. That's going to do it for today's look at the Swagman RV bumper two inch trailer hitch receiver.


Questions and Comments about this Video

Info for this part was:

Employee Jacob T
Video Edited:
Jacob T
Employee Zach D
Video Edited:
Zach D
Employee Cole B
Installed by:
Cole B
Employee Randy B
Installed by:
Randy B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.