Reese Hitch Fabrication Parts - Receiver Tube - 11029 Review

content loading



Customers compare 11029 to these similar products




Products Featured in this Video



Review of Reese Hitch Accessories 11029


Speaker: Today, we're going to review part number 11029. This is the Reese 18-inch long combo bar with the 2 1/2 inch trailer hitch receiver opening in an unpainted finish. This combo bar is designed for use in fabricating an undercover receiver hitch when there's no receiver available. It is made of a cold-formed structural tubing. It is sized and punched, right here, with a 5/8-inch diameter hole. This is made to fit all common weight distributing hitch, ball mounts or utility ball mounts.

Does have a forged collard that's welded to it. It is unpainted, a very unpainted raw finish. This is ideal for welding because it will save of the prep time during installation. A few measurements on this, the over-all length from one end to the other is going to be right at 18 inches. Again, the hitch receiver opening is going to be 2 1/2 by 2 1/2. Again, just to give you a measurement from the edge of the hitch to the center of the hitch pin hole, on this we'll be right at 2 inches.

But that should do it for the review on Part Number 11029, this is the Reese 18-inch long combo bar, with the 2 1/2 inch trailer hitch receiver opening in an unpainted finish. .


Questions and Comments about this Video

add comment

Info for this part was:

Written by:
Lindsey S
Edited By:
Leah B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.