Review of the Redarc In-Vehicle BCDC Trailer Battery Charger Video

The Redarc BCDC Charger part #RED36TR can work with your fridge but it wasn't designed to power accessories directly. You could use it to charge your 12 volt battery that is then powering your 3-way fridge on DC mode though.

Hey Christopher, You could mount some Caliber MultiGlides Snowmobile Trailers #CA26TJ to the floor of your garage but you'd need to drill some holes in the concrete and use some anchors so the screws have something to mount to. Personally, I…

To charge your enclosed car trailer battery and power your accessories you're going to need the Redarc In-Vehicle BCDC Battery Charger - Single Input - DC to DC - 12V/24V - 12 Amp item #RED96FR. You are also going to want the 23-Amp MIDI Fuse Kit…

You can put a maintenance charge on your trailer battery with the 12 volt accessory circuit of the 7-way. The 1:00 position of your 7-way carries this circuit. You would just need to run a length of 10 gauge wire like part #10-1-1 (sold by the foot),…

You would not be able to charge your battery through the wiring on your 4-way trailer connector. Since your truck has a 7-way connector, you could maintain the power to the battery but not charge it. To begin, you would need to cut off your 4-way…

With you trying to run off of just 12v power you're going to limited to just roof vents with a 12v fan to cooler your horse trailer. There isn't a similar option to the #KH43100 without the heater that would be anything other than a simple…

We don't have a specific wiring diagram to add a battery like this but the process isn't overly complicated. You will need a battery box like #329-HM318BKS along with wire #12-1-1 to run to each light and a switch #PK34308 to turn the lights…

The diagram you attached shows a 7-way wired up in what is considered the "traditional way." If you check out the chart I attached you will see the three ways (really only 2), that a 7-way can be wired. The Featherlite is wired up like the…

To trickle charge the battery on your trailer, you will need to convert your 4-Way on your 2013 Honda Odyssey to a 7-Way with something like the Hopkins Wiring Adapter, Item #37185. You will route the purple wire (Auxiliary) of this 7-Way to the…

The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…

The yellow wire of the 7-way harness part #H20044 that you referenced goes to the center pin of the 7-way which is an aux circuit that is typically used for reverse lights if present on the trailer. Normally the red wire on a 7-way (RV standard…

Given the round magnet, it sounds like you have old Hayes 10 x 2-1/4 brake assemblies that have been obsolete for several years, so replacement parts aren't available any longer. Your best bet would be to replace your existing brake assemblies…