Review of Rampage Jeep Accessories - Hand Holds - RA779401

content loading

Customers compare RA779401 to these similar products




Products Featured in this Video



Rampage Jeep Accessories - Hand Holds - RA779401 Review


Today we'll be taking a quick look at the Rampage grab handles for Jeeps. These make a handy accessory to have in your Jeep, especially if you're going to have a lift kit on your Jeep, making it a little bit higher off the ground and now it's a little harder to get in there. You can mount these in a couple different positions in your Jeep. A lot of different . Already existing bolts that you can attach these to whether that's right by the door jam, the back head rest of the front seats, or really anywhere where you can find two bolts that'll make a secure anchor point for these.Comes with two washers per strap, so we'll get four washers total, and two handles. It's made of a pretty rigid molded rubber material so it doesn't really bend at all but it still gives you a good grip to grab and pull yourself into the Jeep.This fits several different Jeep models.

It's specifically designed to work with the 2007 through 2017 Jeep Wrangler and the Jeep Wrangler Unlimited as well as the 2018 Jeep JK Wrangler and Wrangler Unlimited.These really can be used in just about any vehicle that you want to have them installed, anywhere where you want to have a little extra grip again to help you get inside a vehicle, help your kids get pulled up into back seat, or anybody who might have mobility issues.Something that I like about these is that they're semi-rigid when it comes to the handle portion but then the tabs where those grommets are, are more flexible so you can get them mounted up to different positions. Overall, each strap measures about 11 1/2 inches long from the very end to the other end, although the distance between those two grommets at the widest that it can really go is about ten and a quarter inches from the center of each grommet.The narrowest, if we flip those in on each other, that we could mount these is about two and a half inches apart. The outer portion of our handle measures about five inches long from the outside edge to outside edge. Although this semi-rigid portion that's covered by our nylon strap is a little bit longer, and that's about six inches long.The width of the handle is about seven-eighths of an inch and the depth of that curve or how much space this curve takes from the top to the bottom is about an inch and a half. Again, the height on that handle is about seven-eighths or pretty close to an inch.It's molded so you can get your hand on there, even if you have bigger hands than me so it makes a pretty comfortable handle.

So all in all, I think this is a really easy kit to use. No drilling required with this, just simple install with those washers and the straps themselves. We'll have our grommet on either end of the strap to make sure that they stay in place, and give us a long life of service so we don't have to worry about that nylon strap ripping over time as we use the straps but just makes it a little easier to get in and out of your vehicle or just hold on if you're going around some turns pretty quickly.Now that's going to do it for our look at the Rampage grab handles for Jeeps.


Questions and Comments about this Video

Info for this part was:

Video Edited:
Kathleen M
Video Edited:
Dustin K
Test Fit:
Shane H
Video by:
Michael B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.